Search results
Results from the WOW.Com Content Network
Digital model railway control systems are an alternative to control a layout and simplify the wiring and add more flexibility in operations. A number of control systems are available to operate locomotives on model railways. Analog systems where the speed and the direction of a train is controlled by adjusting the voltage on the track are still ...
The car may only have one gear ratio, and the motor simply runs in the opposite direction to make the car go in reverse. Some electric cars with DC motors also have this feature, using an electrical switch to reverse the direction of the motor, but others run the motor in the same direction all the time and use a traditional manual or automatic ...
Servo and receiver connections A diagram showing typical PWM timing for a servomotor. Servo control is a method of controlling many types of RC/hobbyist servos by sending the servo a PWM (pulse-width modulation) signal, a series of repeating pulses of variable width where either the width of the pulse (most common modern hobby servos) or the duty cycle of a pulse train (less common today ...
In contrast, two-rail locos will move in the same direction relative to the track. If the loco is reversed, it will still move in the same (track-relative) direction. By convention, all locos are wired and geared to move consistently, so that double-heading trains is possible. The Marklin stud contact system uses AC motors. These are ...
Digital Command Control (DCC) is a standard for a system for the digital operation of model railways that permits locomotives on the same electrical section of track to be independently controlled. The DCC protocol is defined by the Digital Command Control Working group of the US National Model Railroad Association (NMRA).
The fly-ball actuator was introduced to R/C modelling in 1951 by Brayton Paul, [5] and consisted of an electric motor and a centrifugal governor connected to a free-running axis that could, with the motor running, pull a rudder control rod by varying degrees. Used with a keyed radio system, this allowed some control over the rudder position by ...
When electrical and DC motor technology was first developed, much of the equipment was constantly tended by an operator trained in the management of motor systems. The very first motor management systems were almost completely manual, with an attendant starting and stopping the motors, cleaning the equipment, repairing any mechanical failures ...
A motor controller is a device or group of devices that can coordinate in a predetermined manner the performance of an electric motor. [1] A motor controller might include a manual or automatic means for starting and stopping the motor, selecting forward or reverse rotation, selecting and regulating the speed, regulating or limiting the torque, and protecting against overloads and electrical ...