Search results
Results from the WOW.Com Content Network
A normal cubic meter (Nm 3) is the metric expression of gas volume at standard conditions and it is usually (but not always) defined as being measured at 0 °C and 1 atmosphere of pressure. A standard cubic foot (scf) is the USA expression of gas volume at standard conditions and it is often ( but not always ) defined as being measured at 60 ...
Some express the concentrations as ppmv (parts per million by volume) and some express the concentrations as mg/m 3 (milligrams per cubic meter), while others require adjusting or correcting the concentrations to reference conditions of moisture content, oxygen content or carbon dioxide content.
Its units are in parts per million (ppm) for gases and in milligrams per cubic meter (mg/m 3) for particulates such as dust, smoke and mist. The basic formula for converting between ppm and mg/m 3 for gases is ppm = (mg/m^3) * 24.45 / molecular weight. This formula is not applicable to airborne particles.
769 mg/m 3: 100 ppm: 106934, carcinogenic substance 107-06-2: 0250: Ethylene dichloride: 202.5 mg/m 3: 50 ppm: 107062, carcinogenic substance 628-96-6: 1056: Ethylene glycol dinitrate: 75 mg/m 3-628966: 151-56-4: 0100: Ethyleneimine: 176 mg/m 3: 100 ppm: 151564, carcinogenic substance 75-21-8: 0155: Ethylene oxide: 1440 mg/m 3: 800 ppm: html ...
PELs for chemicals are measured in mg/M 3 (milligrams per cubic meter). [2] Mg/M 3 is used to measure pollutant’s mass in the air. [ 13 ] PELs compliance is monitored through direct reading measurement tools, various sampling methods, and measuring biological markers in workers.
It is often expressed in terms of mg-min/m 3. ICt 50 is the dose that will cause incapacitation rather than death. These measures are commonly used to indicate the comparative efficacy of chemical warfare agents, and dosages are typically qualified by rates of breathing (e.g., resting = 10 L/min) for inhalation, or degree of clothing for skin ...
At 10 000 ppm the solution is a deep red colour. As the concentration decreases the colour becomes orange, then a vibrant yellow, with the final 1 ppm sample a very pale yellow. In science and engineering , the parts-per notation is a set of pseudo-units to describe small values of miscellaneous dimensionless quantities , e.g. mole fraction or ...
where TDS is expressed in mg/L and EC is the electrical conductivity in microsiemens per centimeter at 25 °C. The conversion factor k e varies between 0.55 and 0.8. [5] Some TDS meters use an electrical conductivity measurement to the ppm using the above formula. Regarding units, 1 ppm indicates 1 mg of dissolved solids per 1,000 g of water. [6]