Search results
Results from the WOW.Com Content Network
LS2 can also refer to the 1973–1974 Super Duty 455 cu in (7.5 L) Pontiac V8 engine LS2 can also refer to the 1985 Oldsmobile Diesel V6 engine. The LS2 was introduced as the Corvette's new base engine for the 2005 model year. It also appeared as the standard powerplant for the 2005–2006 GTO.
The 1982 L83 was again the only Corvette engine, producing 200 hp (149 kW) and 285 lb⋅ft (386 N⋅m) of torque from 9.0:1 compression. Since GM did not assign a 1983 model year to production Corvettes, there was no L83 for 1983. [22] This was also the only engine on the 1984 Corvette, at 205 hp (153 kW) and 290 lb⋅ft (393 N⋅m) of torque.
Lift-off oversteer (also known as trailing-throttle oversteer, throttle off oversteer, or lift-throttle oversteer) is a form of sudden oversteer.While cornering, a driver who closes the throttle (by lifting a foot off the accelerator, hence the name), usually at a high speed, can cause such sudden deceleration that the vertical load on the tires shifts from rear to front, in a process called ...
The 2020 Corvette C8 was the first Corvette to have a rear mid-engine configuration, [108] GM's first since the 1984 Pontiac Fiero. The base Stingray coupe was introduced on July 18, 2019, with three launch colors, red (with the Z51 Package), white, and blue, and the convertible on October 2 at the Kennedy Space Center , joined by the C8.R race ...
Other problems may be implicated in the case of older vehicles equipped with carburetors. Weak, disconnected, or mis-connected throttle return springs, worn shot-pump barrels, chafed cable housings, and cables which jump their tracks in the throttle-body crank can all cause similar acceleration problems.
The predecessor of modern electronic traction control systems can be found in high-torque, high-power rear-wheel-drive cars as a limited slip differential.A limited-slip differential is a purely mechanical system that transfers a relatively small amount of power to the non-slipping wheel, while still allowing some wheel spin to occur.
The advent of concern about fuel economy and emissions had major impacts on engine design. Some of the trade-offs reduced throttle response. Most new cars employ a drive-by-wire system, which includes electronic throttle control and can itself either reduce or increase throttle response (Depending on whether or not it's being employed on a performance car).
A throttle position sensor (TPS) is a sensor used to monitor the throttle body valve position for the ECU of an engine. The sensor is usually located on the butterfly spindle/shaft, so that it can directly monitor the position of the throttle. More advanced forms of the sensor are also used.