Search results
Results from the WOW.Com Content Network
British Standard Pipe Parallel Thread Dimensions; British Standard Pipe Taper Thread Dimensions Archived 2017-09-27 at the Wayback Machine; BSP Thread Charts and Diagrams, showing dimensions of tubing and fittings; ISO 7-1:1994; ISO 7-2:2000; ISO 228-1:2000; ISO 228-2:1987; Parallel pipe threads G; Parallel pipe threads PF
Tables of BS Whitworth, BS Fine and BS Pipe Threads: V Thread Form (55°) 1 ⁄ 4 ″-20 BSW ISO 68-1:1998: ISO general purpose screw threads—Basic profile—Part 1: Metric screw threads: V Thread Form ISO 68-2:1998: ISO general-purpose screw threads—Basic profile—Part 2: Inch screw threads: V Thread Form ISO 261:1998: ISO general purpose ...
The Whitworth 55° angle remains commonly used today worldwide in form of the 15 British standard pipe threads defined in ISO 7, which are commonly used in water supply, cooling, pneumatics, and hydraulic systems. These threads are designated by a number between 1/16 and 6 that originates from the nominal internal diameter (i/d) in inches of a ...
The taper rate for all NPT threads is 1 inch of diameter in 16 inches of length (3 ⁄ 4 inch per foot or 62.5 millimeters per meter) measured by the change of diameter (of the pipe thread) over distance of thread.
The standard designation for a UTS thread is a number indicating the nominal (major) diameter of the thread, followed by the pitch measured in threads per inch.For diameters smaller than 1 / 4 inch, the diameter is indicated by an integer number defined in the standard; for all other diameters, the inch figure is given.
No thread 1 1/4" x 5 ACME LH (G.30) EN 15202 No thread LH 7/16" UNEF camping: ... DIN 477-1 No. 4 BSP: 16.7 mm 1.337 mm 3/8" 19 TPI Dish Autogas Dish No thread INT
British standard pipe thread: G 55° DIN / BS / EN / ISO 228-1 / ISO 7-1 National Pipe Thread NPT 60° ASME B1.20.-1983 Pipe Threads, General Purpose, Inch
A diagram of an ISO metric or Unified thread, showing dimensions relative to the pitch (P) and thread height (H). Due to different standards, ISO and UTS share the same geometry, but not absolute dimensions. Also shown is the location rounding permissible in internal (dark grey, top) and external (light grey, bottom) threads. Key. P: Pitch; H ...