Search results
Results from the WOW.Com Content Network
Voice coils can be used for applications other than loudspeakers, where time force linearity and long strokes are needed. Some environments like vacuum or space require specific attention during conception, in order to evacuate coil losses. Several specific methods can be used to facilitate thermal drain.
Constant-voltage speaker systems are also commonly referred to as 25-, 70-, 70.7-, 100 or 210-volt speaker systems; distributed speaker systems; or high-impedance speaker systems. In Canada and the US, they are most commonly referred to as 70-volt speakers. In Europe, the 100 V system is the most widespread, with amplifier and speaker products ...
Anker Innovations Co., Ltd, [a] commonly known as Anker, [b] is a Chinese electronics manufacturer based in Changsha, Hunan, China.The company's product range includes phone chargers, power banks, earbuds, headphones, speakers, data hubs, 3D printers, charging cables, torches (flashlights), and screen protectors, among other products.
A loudspeaker (commonly referred to as a speaker or, more fully, a speaker system) is a combination of one or more speaker drivers, an enclosure, and electrical connections (possibly including a crossover network). The speaker driver is an electroacoustic transducer [1]: 597 that converts an electrical audio signal into a corresponding sound. [2]
4-pin speaker connector (marked SPK) on motherboard Tiny moving-iron PC speaker uses 4-pin 2-wire connection. In some applications, the PC speaker is affixed directly to the computer's motherboard; in others, including the first IBM Personal Computer, the speaker is attached by wire to a connector on the motherboard. Some PC cases come with a ...
Early speaker cable was typically stranded copper wire, insulated with cloth tape, waxed paper or rubber. For portable applications, common lampcord was used, twisted in pairs for mechanical reasons. Cables were often soldered in place at one end. Other terminations were binding posts, terminal strips, and spade lugs for crimp connections.
All speaker drivers have a means of electrically inducing back-and-forth motion. Typically there is a tightly wound coil of insulated wire (known as a voice coil) attached to the neck of the driver's cone. In a ribbon speaker, the voice coil may be printed or bonded onto a sheet of very thin paper, aluminum, fiberglass or plastic.
The middle speaker is a real loudspeaker. The top and bottom cones are passive radiators. In the same way as a ported loudspeaker, a passive radiator system uses the sound pressure otherwise trapped in the enclosure to excite a resonance that makes it easier for the speaker system to create the deepest pitches (e.g., basslines). The passive ...