enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Constant-voltage speaker system - Wikipedia

   en.wikipedia.org/wiki/Constant-voltage_speaker...

   Constant-voltage speaker systems are also commonly referred to as 25-, 70-, 70.7-, 100 or 210-volt speaker systems; distributed speaker systems; or high-impedance speaker systems. In Canada and the US, they are most commonly referred to as 70-volt speakers. In Europe, the 100 V system is the most widespread, with amplifier and speaker products ...

3. Thiele/Small parameters - Wikipedia

   en.wikipedia.org/wiki/Thiele/Small_parameters

   American EIA standard RS-299A specifies that (or DCR) should be at least 80% of the rated driver impedance, so an 8-ohm rated driver should have a DC resistance of at least 6.4 ohms, and a 4-ohm unit should measure 3.2 ohms minimum. This standard is voluntary, and many 8-ohm drivers have resistances of ≈5.5 ohms, and proportionally lower for ...

4. Speaker wire - Wikipedia

   en.wikipedia.org/wiki/Speaker_wire

   [citation needed] High-power in-car audio systems using 2-ohm speaker circuits require thicker wire than 4 to 8-ohm home audio applications. Most consumer applications use two conductor wire. A common rule of thumb is that the resistance of the speaker wire should not exceed 5 percent of the rated impedance of the system.

5. Audio power - Wikipedia

   en.wikipedia.org/wiki/Audio_power

   Typical loads used are 8 and 4 ohms per channel; many amplifiers used in professional audio are also specified at 2 ohms. Considerably more power can be delivered if distortion is allowed to increase; some manufacturers quote maximum power at a higher distortion, like 10%, making their equipment appear more powerful than if measured at an ...

6. Coaxial loudspeaker - Wikipedia

   en.wikipedia.org/wiki/Coaxial_loudspeaker

   A coaxial loudspeaker is a loudspeaker system in which the individual driver units radiate sound from the same point or axis. Two general types exist: one is a compact design using two or three speaker drivers, usually in car audio, and the other is a two-way high-power design for professional audio, also known as single-source or dual-concentric loudspeakers. [1]

7. Line level - Wikipedia

   en.wikipedia.org/wiki/Line_level

   Line out provides an audio signal output and line in receives a signal input. The line in/out connections on consumer-oriented audio equipment are typically unbalanced, with a 3.5 mm (0.14 inch, but commonly called "eighth inch") 3-conductor TRS minijack connector providing ground, left channel, and right channel, or stereo RCA jacks.