Search results
Results from the WOW.Com Content Network
On the other hand, if the power supply has a voltage selector switch, based on the Delon circuit, for 115/230 V (computer ATX power supplies typically are in this category), the selector switch would have to be put in the 230 V position, and the required voltage would be 325 VDC (230 × √2).
A high-voltage power supply powered by wall power is used, which may be a simple transformerless voltage multiplier circuit made with diodes and capacitors which can generate a voltage of 2 kilovolts or more. This is high enough to conduct through the body of an insect which bridges the two grids, but not high enough to spark across the air gap.
A typical flyswatter. A flyswatter (or fly-swat, fly swatter [1]) usually consists of a small rectangular or round sheet of a lightweight, flexible, vented material (usually thin metallic, rubber, or plastic mesh) around 10 cm (4 in) across, attached to a handle about 30 to 60 cm (1 to 2 ft) long made of a lightweight material such as wire, wood, plastic, or metal.
For premium support please call: 800-290-4726 more ways to reach us
Contactor with overload relay. A magnetic starter is an electromagnetically operated switch which provides a safe method for starting an electric motor with a large load. . Magnetic starters also provide under-voltage and overload protection and an automatic cutoff in the event of a power fai
An external power supply, AC adapter or power brick, is a power supply located in the load's AC power cord that plugs into a wall outlet; a wall wart is an external supply integrated with the outlet plug itself. These are popular in consumer electronics because of their safety; the hazardous 120 or 240 volt main current is transformed down to a ...
An electropermanent magnet or EPM is a type of permanent magnet in which the external magnetic field can be switched on or off by a pulse of electric current in a wire winding around part of the magnet. The magnet consists of two sections, one of "hard" (high coercivity) magnetic material and one of "soft" (low coercivity) material. The ...
The advantage of this persistent mode is that stability of the magnetic field is better than is achievable with the best power supplies, and no energy is needed to power the windings. The short circuit is made by a 'persistent switch', a piece of superconductor inside the magnet connected across the winding ends, attached to a small heater. [5]