Search results
Results from the WOW.Com Content Network
SCPI commands to an instrument may either perform a set operation (e.g. switching a power supply on) or a query operation (e.g. reading a voltage). Queries are issued to an instrument by appending a question-mark to the end of a command. Some commands can be used for both setting and querying an instrument.
The clock generator in a motherboard is often changed by computer enthusiasts to control the speed of a CPU, FSB, GPU or RAM. Typically the programmable clock generator is set by the BIOS at boot time to the selected value; although some systems have dynamic frequency scaling, which frequently re-programs the clock generator.
A PLC is an industrial microprocessor-based controller with programmable memory used to store program instructions and various functions. [21] It consists of: A processor unit (CPU) which interprets inputs, executes the control program stored in memory and sends output signals, A power supply unit which converts AC voltage to DC,
It carries clock, data, and instructions and is based on Philips' I²C serial bus protocol. [1] Its clock frequency range is 10 kHz to 100 kHz. (PMBus extends this to 400 kHz.) Its voltage levels and timings are more strictly defined than those of I²C, but devices belonging to the two systems are often successfully mixed on the same bus.
Below is the full 8086/8088 instruction set of Intel (81 instructions total). [2] These instructions are also available in 32-bit mode, in which they operate on 32-bit registers (eax, ebx, etc.) and values instead of their 16-bit (ax, bx, etc.) counterparts.
At one end is the manual gating of clocks by software, where a driver enables or disables the various clocks used by a given idle controller. On the other end is automatic clock gating, where the hardware can be told to detect whether there is any work to do, and turn off a given clock if it is not needed.
Watchdog timers come in many configurations, and many allow their configurations to be altered. For example, the watchdog and CPU may share a common clock signal as shown in the block diagram below, or they may have independent clock signals or in some cases the watchdog may have no clock signal at all. A basic watchdog timer has a single timer ...
The 2650A was a reworked version of the original layout intended to improve yield, and thus reduce cost. Speed remained unchanged at 1.25 MHz for the base model and 2 MHz for the -1 versions. The 2650B was based on the A, added two new instructions, and improved the performance of a number of existing instructions. [2]