enow.com Web Search

  1. Ads

    related to: generator capacitor size chart for house heating

Search results

  1. Results from the WOW.Com Content Network
  2. Capability curve - Wikipedia

    en.wikipedia.org/wiki/Capability_curve

    Due to high cost of a generator, a set of sensors and limiters will trigger the alarm when the generator approaches the capability-set boundary and, if no action is taken by the operator, will disconnect the generator from the grid. [3] D-curve expands with cooling. The D-curve for a particular generator can be expanded by improved cooling.

  3. Induction generator - Wikipedia

    en.wikipedia.org/wiki/Induction_generator

    For a machine to run as an asynchronous generator, capacitor bank must supply minimum 4567 / 3 phases = 1523 VAR per phase. Voltage per capacitor is 440 V because capacitors are connected in delta. Capacitive current Ic = Q/E = 1523/440 = 3.46 A Capacitive reactance per phase Xc = E/Ic = 127 Ω. Minimum capacitance per phase:

  4. ESR meter - Wikipedia

    en.wikipedia.org/wiki/ESR_meter

    Measuring ESR can be done by applying an alternating voltage at a frequency at which the capacitor's reactance is negligible, in a voltage divider configuration. It is easy to check ESR well enough for troubleshooting by using an improvised ESR meter comprising a simple square-wave generator and oscilloscope, or a sinewave generator of a few tens of kilohertz and an AC voltmeter, using a known ...

  5. Capacitor types - Wikipedia

    en.wikipedia.org/wiki/Capacitor_types

    A capacitor can act as an AC resistor, coupling AC voltage and AC current between two points. Every AC current flow through a capacitor generates heat inside the capacitor body. These dissipation power loss is caused by and is the squared value of the effective (RMS) current

  6. Capacity factor - Wikipedia

    en.wikipedia.org/wiki/Capacity_factor

    For a wind farm, the capacity factor is determined by the availability of wind, the swept area of the turbine and the size of the generator. Transmission line capacity and electricity demand also affect the capacity factor. Typical capacity factors of current wind farms are between 25 and 45%. [12]

  7. E series of preferred numbers - Wikipedia

    en.wikipedia.org/wiki/E_series_of_preferred_numbers

    While the standard only specifies a tolerance greater than 20%, other sources indicate 40% or 50%. Currently, most electrolytic capacitors are manufactured with values in the E6 or E12 series, thus E3 series is mostly obsolete.

  1. Ads

    related to: generator capacitor size chart for house heating