Ad
related to: ford module programming with j2534
Search results
Results from the WOW.Com Content Network
A passthrough device is a device used in conjunction with a computer to reprogram vehicle control modules through the OBD-II/CANbus port. [1] Each manufacturer has their own type, but SAE International standardized the J-2534 universal requirements in 2004, requiring all manufacturers to allow vehicles sold in the United States of America and Europe to accept powertrain reprogramming through ...
This system was used on certain 1980-83 vehicles. There were two different EEC-III modules; one for use with a feedback carburetor, and one for use with Ford's "Central" throttle-body fuel injection system. The module size and shape were approximately the same as the EEC-II and still utilized the external memory module.
OBD-II PIDs (On-board diagnostics Parameter IDs) are codes used to request data from a vehicle, used as a diagnostic tool.. SAE standard J1979 defines many OBD-II PIDs. All on-road vehicles and trucks sold in North America are required to support a subset of these codes, primarily for state mandated emissions inspections.
Mercedes (K-Line): All activity module (AAM), Radio (RD), ICS (and more) 5 Signal ground: 13 Manufacturer discretion. Ethernet RX- (Diagnostics over IP) Ford: FEPS – Programming PCM voltage Mercedes (K-Line): AB diagnostic – safety systems. 6 CAN high (ISO 15765-4 and SAE J2284) 14 CAN low (ISO 15765-4 and SAE J2284) 7 K-line
Ford announced in 2014 plans to reduce its vehicle platforms from sixteen to nine. [1] In 2014, Ford vehicles were built on fifteen distinct platforms. This only applies to Ford and Lincoln and not to any brands that were previously held by the company (such as Mazda and Volvo), and is expected to cut costs by 20%.
A host of functions required for ECU software calibration, such as interface-dependent calibration methods, calibration data management, measurement data visualization and analysis, ECU programming, vehicle bus monitoring, as well as remote control through standard interfaces, are part of the product's functional complement.
The ELM327 abstracts the low-level protocol and presents a simple interface that can be called via a UART, typically by a hand-held diagnostic tool or a computer program connected by USB, RS-232, Bluetooth or Wi-Fi. [2] New applications include smartphones. [3] There are a large number of programs available that connect to the ELM327. [4] [5]
The Ford Work Solution is a collection of technologies debuted in April 2009. Ford Work Solutions is marketed toward professionals who buy the Ford F150, F-Series Super Duty, E-Series van and Transit Connect. [16] Magneti Marelli developed the in-dash computer system that is unique to trucks equipped with Ford Work Solutions. [17]
Ad
related to: ford module programming with j2534