Search results
Results from the WOW.Com Content Network
Electrical cord for powering a block heater. A block heater is used in cold climates to warm an engine prior to starting. They are mostly used for car engines; however, they have also been used in aircraft engines. The most common design of block heater is an electrical heating element embedded in the engine block.
Core plugs can also sometimes prevent freeze damage to the motor. During the early stages of the freezing of the engine coolant a freeze plug will sometimes burst or pop out, and thus allow the coolant to exit the engine, before it might expand within the engine during the freezing process and potentially crack the engine block. [2]
Glowplugs are typically used as starting-aid devices, when the engine is being cranked by a starter motor, and in most cases switched off when the engine has reached a defined minimum operating temperature. Diesel engines, unlike common spark-ignition engines, do not use spark plugs to ignite the air-fuel mixture. Instead, they rely solely on ...
Engine bay of a 1993 Jeep Grand Cherokee with 4.0 L The 5 millionth Jeep 4.0 engine produced on the "Greenlee Block Line" dated June 15, 2001 The 242 cu in (4.0 L) engine was developed by AMC in just 26 months using many off-the-shelf components while featuring, among others, additional strength, improved combustion chamber, port setup, and cam ...
Production on the 3.3 was stopped in 2010 after a run of 5,076,603 [2] engines, while the 3.8 remained in production until May 2011 in Trenton, Michigan for the Jeep Wrangler. Both use a cast iron block and aluminum heads.
The AMC straight-4 engine is a 2.5 L straight-four engine developed by American Motors Corporation (AMC) that was used in a variety of AMC, Jeep, and Dodge vehicles from 1984 through 2002. The 2.5 L I4 Jeep engine shared design elements and some internal components with the AMC 4.0 L I6 that was introduced for the 1987 model year.
This was so named because it began with Chevrolet's V8 engines. Chevrolet big-block V8s; Chevrolet small-block V8s; GM Vortec 4300 90° V6; GM Iron Duke RWD inline 4 (early RWD Variants, later versions may use a FWD pattern, and have two possible starter locations) Jeep with GM Iron Duke inline 4 2.5L/151 in 3 (1980-1983).
This engine was also used in some early Toyota Land Cruisers & Hilux, and Opel Fronteras. The 425 OHV used in Chrysler Voyager 1991–2000 only 1996 and 1997 was with chain. Between 1997 and 2001 this engine was manufactured at "Detroit Diesel Motores do Brasil" in Curitiba, Paraná, Brazil.