Search results
Results from the WOW.Com Content Network
The California Bearing Ratio (CBR) is a measure of the strength of the subgrade of a road or other paved area, and of the materials used in its construction. The ratio is measured using a standardized penetration test first developed by the California Division of Highways for highway engineering. [1] Empirical tests measure the strength of the ...
ACN-PCN method. The Aircraft Classification Number (ACN) – Pavement Classification Number (PCN) method is a standardized international airport pavement rating system promulgated by the ICAO in 1981. The method has been the official ICAO pavement rating system for pavements intended for aircraft of apron (ramp) mass greater than 5700 kg from ...
A sieve analysis (or gradation test) is a practice or procedure used in geology, civil engineering, [1] and chemical engineering [2] to assess the particle size distribution (also called gradation) of a granular material by allowing the material to pass through a series of sieves of progressively smaller mesh size and weighing the amount of material that is stopped by each sieve as a fraction ...
R-value (soils) The R-Value test [1] measures the response of a compacted sample of soil or aggregate to a vertically applied pressure under specific conditions. This test is used by Caltrans for pavement design, replacing the California bearing ratio test. Many other agencies have adopted the California pavement design method, and specify R ...
The Proctor compaction test is a laboratory method of experimentally determining the optimal moisture content at which a given soil type will become most dense and achieve its maximum dry density. The test is named in honor of Ralph Roscoe Proctor [ de ] , who in 1933 showed that the dry density of a soil for a given compactive effort depends ...
The edge crush test is a laboratory test method that is used to measure the cross-direction crushing of a sample of corrugated board. It gives information on the ability of a particular board construction to resist crushing. It provides some relationship with the peak top-to-bottom compression strength of empty singlewall regular slotted ...
The test method consists of pushing an instrumented cone, with the tip facing down, into the ground at a controlled rate (controlled between 1.5 -2.5 cm/s accepted). The resolution of the CPT in delineating stratigraphic layers is related to the size of the cone tip, with typical cone tips having a cross-sectional area of either 10 or 15 cm 2 ...
The so-called CBR-value represents the ratio of the percentage of the loads required to press a punch of certain dimensions first into a well compacted sample of soil and then into a standard sample of compacted gravels, to a depth of 0.1 inch. In any case, it is necessary to classify the soil type with reference to the Unified Soil ...