Search results
Results from the WOW.Com Content Network
By default, the output value is rounded to adjust its precision to match that of the input. An input such as 1234 is interpreted as 1234 ± 0.5, while 1200 is interpreted as 1200 ± 50, and the output value is displayed accordingly, taking into account the scale factor used in the conversion.
Converts measurements to other units. Template parameters [Edit template data] This template prefers inline formatting of parameters. Parameter Description Type Status Value 1 The value to convert. Number required From unit 2 The unit for the provided value. Suggested values km2 m2 cm2 mm2 ha sqmi acre sqyd sqft sqin km m cm mm mi yd ft in kg g mg lb oz m/s km/h mph K C F m3 cm3 mm3 L mL cuft ...
The inner contact on the 7-16 DIN connector measures 7 mm in outer diameter while the outer contact on the connector measures 16 mm. in inner diameter [3] DIN is an acronym for the Deutsches Institut für Normung, the standards organization that harmonized the standard for the connector. (Previously the 7-16 had been developed as a military ...
The template formats a track gauge size into standard notation and adds the conversion into the imperial/metric (other) size Template parameters [Edit template data] Parameter Description Type Status Track gauge definition 1 Defined track gauge, in mm or ft in. Also can accept: ' '', m, gauge name String required Link top measurement units lk =on: adds link to the gauge defining article String ...
Using 32 mm (1.26 in) - 0 gauge - track, there is an extensive range of 16 mm to the foot scale [1:19] live-steam and other types of locomotives, rolling stock and accessories. Many of these models are dual gauge, and can be converted to run on 45 mm ( 1.772 in ) track ( gauge 1 ), and radio control is common.
There have been numerous issues of converting measurements, using Template:Convert, during 2008-2009.That template-family is becoming increasingly harder to update, due to the growing complexity of the 20-to-26 nested templates for each conversion, and the continual deletion of similar templates that could have been used to compare for errors.
Air cored Microwave connectors The name of a connector (e.g. 1.85) is determined by the diameter in mm of the air dielectric around the centre pin 3.5 and 2.92 mm (sometimes called K) connectors, which also have a 0.9mm centre pin and cross-mate with SMA and offer higher maximum frequency
Drill bit sizes are written as irreducible fractions. So, instead of 78/64 inch, or 1 14/64 inch, the size is noted as 1 7/32 inch. Below is a chart providing the decimal-fraction equivalents that are most relevant to fractional-inch drill bit sizes (that is, 0 to 1 by 64ths).