Search results
Results from the WOW.Com Content Network
Frequency modulation and phase modulation are the two complementary principal methods of angle modulation; phase modulation is often used as an intermediate step to achieve frequency modulation. These methods contrast with amplitude modulation , in which the amplitude of the carrier wave varies, while the frequency and phase remain constant.
Change in resonant frequency of AFM sensor driven off resonance (amplitude modulation mode) causes a change in amplitude. Amplitude modulation was one of the original modes of operation introduced by Binnig and Quate in their seminal 1986 AFM paper, [5] in this mode the sensor is excited just off resonance. By exciting the sensor just above its ...
In analog modulation, an analog modulation signal is "impressed" on the carrier. Examples are amplitude modulation (AM) in which the amplitude (strength) of the carrier wave is varied by the modulation signal, and frequency modulation (FM) in which the frequency of the carrier wave is varied by the
Frequency can be measured with very high sensitivity and thus the frequency modulation mode allows for the use of very stiff cantilevers. Stiff cantilevers provide stability very close to the surface and, as a result, this technique was the first AFM technique to provide true atomic resolution in ultra-high vacuum conditions.
The modulating frequency changes between 1,500 and 2,300 Hz, corresponding to the intensity of the color component. The modulation is analog, so even though the horizontal resolution is often defined as 256 or 320 pixels, they can be sampled using any rate. The image aspect ratio is conventionally 4:3. Lines usually end in a 1,200 Hz horizontal ...
Chirp modulation, or linear frequency modulation for digital communication, was patented by Sidney Darlington in 1954 with significant later work performed by Winkler in 1962. This type of modulation employs sinusoidal waveforms whose instantaneous frequency increases or decreases linearly over time.
Most amateur digital modes are transmitted by inserting audio into the microphone input of a radio and using an analog scheme, such as amplitude modulation (AM), frequency modulation (FM), or single-sideband modulation (SSB). Amateur teleprinting over radio (AMTOR) D-STAR (Digital Data) a high speed (128 kbit/s), data-only mode.
It could be the transfer of an analog signal, using an analog modulation method such as frequency modulation (FM) or amplitude modulation (AM), or no modulation at all. Some textbooks also consider passband data transmission using a digital modulation method such as ASK, PSK and QAM, i.e. a sinewave modulated by a digital bit-stream, as analog ...