Search results
Results from the WOW.Com Content Network
The DL-41xx series came out in 2013. It is a USB 3.0 to LVDS device, supporting DL3 compression and HDCP 2.0 encryption. [26] It is designed to be embedded into monitors to enable USB as a video input on displays. It is described as a low-power device, which enables it to be powered from the USB bus without the need for an external power supply.
USB 3.0 port provided by an ExpressCard-to-USB 3.0 adapter may be connected to a separately-powered USB 3.0 hub, with external devices connected to that USB 3.0 hub. On the motherboards of desktop PCs which have PCI Express (PCIe) slots (or the older PCI standard), USB 3.0 support can be added as a PCI Express expansion card .
30 pin receptacle including the following electrical interfaces: 2-lane DisplayPort v1.1a, USB 3.0, USB On-The-Go, Analog stereo line-out, HDMI CEC for remote control, high output power line from both host and portable device Male Mini-VGA plug on top of an Apple laptop, female port is second from right. Mini-VGA (used for laptops)
The 12-inch Retina MacBook (early 2015) has only one expansion port, a USB-C port that supports charging, external displays, and Target Disk Mode. Using Target Disk Mode on this MacBook requires a cable that supports USB 3.0 or USB 3.1, with either a USB-A or USB-C connector on one end and a USB-C connector on the other end for the MacBook. [5]
The xHCI reduces the need for periodic device polling by allowing a USB 3.0 or later device to notify the host controller when it has data available to read, and moves the management of polling USB 2.0 and 1.1 devices that use interrupt transactions from the CPU-driven USB driver to the USB host controller.
A USB OTG setup involving a number of devices. Standard USB uses a host/device architecture; a host acts as the Host device for the entire bus, and a USB device acts as a Peripheral. If implementing standard USB, devices must assume one role or the other, with computers generally set up as hosts, while (for example) printers normally function ...
In VirtualLink mode, there were six high-speed lanes active in the USB-C connector and cable: four lanes transmit four DisplayPort HBR 3 video streams from the PC to the headset while two lanes implement a bidirectional USB 3.1 Gen 2 channel between the PC and the headset. Unlike the classic DisplayPort USB-C alternate mode, VirtualLink has no ...
Detection of UVC 1.5 devices was introduced in Linux kernel version 4.5, [5] but support in the driver for UVC 1.5 specific features or specific UVC 1.5 devices was not added and MPEG-2 TS, H.264 and VP8 payloads are not supported yet. The result is that some UVC 1.5 devices that also support UVC 1.1 work correctly.