Search results
Results from the WOW.Com Content Network
The GM Muncie Transmission plant was demolished soon after turnover to the county. [7] The Syracuse New Process remained with New Venture Gear. In 2004, Magna International purchased 80% of New Venture Gear from DaimlerChrysler and put it under Magna Drivetrain. [8] Magna purchased the remaining 20% interest in 2007. [9]
400 N⋅m (295 lb⋅ft) 1987 – 2004 Longitudinal: 2.7331 0.7281 4 3.7539 1.5541 1.4106 S 3 4 3 Torque Converter w/ Lockup Hydraulic 4HP 24: 400 N⋅m (295 lb⋅ft) 1987 – 2004 Longitudinal: 2.4795 0.7281 4 3.4055 1.5045 1.3436 S 3 4 3 Torque Converter w/ Lockup Hydraulic 4HP 20: TBD 1995 – Transverse: TBD 4 TBD TBD S 3 2 3 Torque ...
The New Venture Gear 4500, colloquially known as NV4500, is a 5-speed manual transmission manufactured by New Venture Gear and used in General Motors and Chrysler products from 1991 to 2007. The NV4500 is used in light trucks and SUVs including Toyota, Ford, Jeep, General Motors, and Dodge. Commercially produced adapters are available to mate ...
The 2.2l S10/Sonoma had the starter located in the same position as front wheel drive cars. A rear wheel drive bellhousing is displayed at right, and the integrated front wheel drive bellhousing is displayed at the lower right (in this case, as a part of the GM 6T70 Transmission). GM 60-Degree 2.8/3.1/3.4/3.5/3.9 L V6 (also used by AMC) Buick ...
The New Venture Gear 3500, commonly called NV3500, is a 5-speed overdrive manual transmission manufactured by New Venture Gear and used by GM and Dodge in compact and full-size light trucks. It can be identified by its two-piece aluminum case with integrated bell housing and top-mounted tower shifter.
Saginaw M26/27 transmission — 3 and 4-speed longitudinal light duty (less than 300 hp) wide ratio manual transmission made by GM at their Saginaw, Michigan factory; Muncie M62/M64 — 3-speed longitudinal transmission made by GM; Muncie SM318 transmission — 3-speed transmission used from 1954 through 1969 in both passenger car and truck ...
The TH400 was phased out for the 1980 models, when the A-727 replaced the TH-400 as the only automatic transmission option for both the SJ Wagoneer/Cherokee wagons and the J-10/J-20 trucks. Internally similar to the Chrysler A-727, the case was one-piece, cast with an AMC pattern bellhousing (not interchangeable with a Chrysler pattern A-727).
The parking pawl locks the transmission's output shaft to the transmission casing by engaging a pawl (a pin) that engages in a notched wheel on the shaft, stopping it (and thus the driven wheels) from rotating. The main components of a parking pawl mechanism are the parking gear, parking pawl, actuator rod, cam collar, cam plate, pivot pin, and ...