enow.com Web Search

Search results

  1. Results from the WOW.Com Content Network
  2. I3C (bus) - Wikipedia

    en.wikipedia.org/wiki/I3C_(bus)

    Pull-up resistors are provided by the I3C controller. External pull-up resistors are no longer needed. Clock Stretching – devices are expected to be fast enough to operate at bus speed. The I3C controller is the sole clock source. I²C Extended (10-bit) Addresses. All devices on an I3C bus are addressed by a 7-bit address.

  3. Pull-up resistor - Wikipedia

    en.wikipedia.org/wiki/Pull-up_resistor

    A standard TTL input at logic "1" is normally operated assuming a source current of 40 μA, and a voltage level above 2.4 V, allowing a pull-up resistor of no more than 50 kohms; whereas the TTL input at logic "0" will be expected to sink 1.6 mA at a voltage below 0.8 V, requiring a pull-down resistor less than 500 ohms. [2]

  4. RC time constant - Wikipedia

    en.wikipedia.org/wiki/RC_time_constant

    It is the time required to charge the capacitor, through the resistor, from an initial charge voltage of zero to approximately 63.2% of the value of an applied DC voltage, or to discharge the capacitor through the same resistor to approximately 36.8% of its initial charge voltage.

  5. Resistor - Wikipedia

    en.wikipedia.org/wiki/Resistor

    A pull-up or pull-down resistor provides a voltage for a circuit when it is otherwise disconnected (such as when a button is not pushed down or a transistor is not active). A pull-up resistor connects the circuit to a high positive voltage (if the circuit requires a high positive default voltage) and a pull-down resistor connects the circuit to ...

  6. Time constant - Wikipedia

    en.wikipedia.org/wiki/Time_constant

    First order LTI systems are characterized by the differential equation + = where τ represents the exponential decay constant and V is a function of time t = (). The right-hand side is the forcing function f(t) describing an external driving function of time, which can be regarded as the system input, to which V(t) is the response, or system output.

  7. Open collector - Wikipedia

    en.wikipedia.org/wiki/Open_collector

    One problem such open-collector and similar devices with a pull-up resistor is the resistor consumes power constantly while the output is low. Higher operating speeds require lower resistor values for faster pull-up, which consume even more power.

  8. RC circuit - Wikipedia

    en.wikipedia.org/wiki/RC_circuit

    A resistor–capacitor circuit (RC circuit), or RC filter or RC network, is an electric circuit composed of resistors and capacitors. It may be driven by a voltage or current source and these will produce different responses. A first order RC circuit is composed of one resistor and one capacitor and is the simplest type of RC circuit.

  9. Resistor–transistor logic - Wikipedia

    en.wikipedia.org/wiki/Resistor–transistor_logic

    If all the input voltages are low (logical "0"), the transistor is cut-off. The pull-down resistor R 1 biases the transistor to the appropriate on-off threshold. The output is inverted since the collector-emitter voltage of transistor Q 1 is taken as output, and is high when the inputs are low. Thus, the analog resistive network and the analog ...