Search results
Results from the WOW.Com Content Network
The Dynamic Host Configuration Protocol (DHCP) is a network management protocol used on Internet Protocol (IP) networks for automatically assigning IP addresses and other communication parameters to devices connected to the network using a client–server architecture.
Zero-configuration networking (zeroconf) is a set of technologies that automatically creates a usable computer network based on the Internet Protocol Suite (TCP/IP) when computers or network peripherals are interconnected. It does not require manual operator intervention or special configuration servers.
To enable the forwarding of User Datagram Protocol (UDP) broadcasts, including BOOTP, received on an interface, use the ip helper-address command in interface configuration mode. To disable the forwarding of broadcast packets to specific addresses, use the no form of this command.
[1]: 1.9 Therefore, hosts search for a DHCP server on the network before assigning link-local addresses. In the automatic address configuration process, network hosts select a random candidate address within the reserved range and use Address Resolution Protocol (ARP) probes to ascertain that the address is not in use on the network. If a reply ...
The Dynamic Host Configuration Protocol version 6 (DHCPv6) is a network protocol for configuring Internet Protocol version 6 (IPv6) hosts with IP addresses, IP prefixes, default route, local segment MTU, and other configuration data required to operate in an IPv6 network.
On Windows XP, the server, by default, gets the IP address 192.168.0.1. (This default can be changed within the interface settings of the network adapter or in the Windows Registry.) It provides NAT services to the entire 192.168.0.x subnet, even if the address on the client was set manually, not by the DHCP server.
On Linux and all Unix-like operating systems, the utilities ifconfig and the newer ip (from the iproute2-bundle) are used to configure IEEE 802.3 and IEEE 802.11 hardware. These utilities configure the kernel directly and the configuration is applied immediately. After boot-up, the user is required to configure them again.
Some DHCP servers also provide the legacy BOOTP functionality. When a network-connected computer boots up, its IP stack broadcasts BOOTP network messages requesting an IP address assignment. A BOOTP configuration server replies to the request by assigning an IP address from a pool of addresses, which is preconfigured by an administrator.