Search results
Results from the WOW.Com Content Network
In a medicine that is administered periodically, the trough level should be measured just before the administration of the next dose in order to avoid overdosing. [3] A trough level is contrasted with a "peak level" (C max), which is the highest level of the medicine in the body, and the "average level", which is the mean level over time. It is ...
Peak-to-trough ratio in pharmacokinetics is the ratio of peak (C max) and trough (C min) levels of a drug over its dosing interval (τ) at steady state.. Peak-to-trough ratio (PTR), also known as peak-to-trough variation or peak-to-trough fluctuation, is a parameter in pharmacokinetics which is defined as the ratio of C max (peak) concentration and C min (trough) concentration over a dosing ...
At a practical level, a drug's bioavailability can be defined as the proportion of the drug that reaches the systemic circulation. From this perspective the intravenous administration of a drug provides the greatest possible bioavailability, and this method is considered to yield a bioavailability of 1 (or 100%).
Peak discharge the highest point on the hydrograph when the rate of discharge is greatest. Recession (or falling) limb The recession limb extends from the peak flow rate onward. The end of stormflow (a.k.a. quickflow or direct runoff) and the return to groundwater-derived flow is often taken as the point of inflection of the recession limb. The ...
Static level is the level of water in the well when no water is being removed from the well by pumping. [8] Water table is the upper level of the zone of saturation, an underground surface in which the soil or rock is permanently saturated with water. [9] Well yield is the volume of water per unit time that is produced by the well from pumping. [8]
In hydrometry, the volumetric flow rate is known as discharge. Volumetric flow rate should not be confused with volumetric flux, as defined by Darcy's law and represented by the symbol q, with units of m 3 /(m 2 ·s), that is, m·s −1. The integration of a flux over an area gives the volumetric flow rate. The SI unit is cubic metres per ...
Calorimetry may be used to monitor the course of a reaction, since the instantaneous heat flux of the reaction, which is directly related to the enthalpy change for the reaction, is monitored. Reaction calorimetry may be classified as a differential technique since the primary data collected are proportional to rate vs. time.
This depth is converted to a flow rate according to a theoretical formula of the form = where is the flow rate, is a constant, is the water level, and is an exponent which varies with the device used; or it is converted according to empirically derived level/flow data points (a "flow curve"). The flow rate can then be integrated over time into ...