Search results
Results from the WOW.Com Content Network
The 2mm Pinfire is a pistol cartridge for small 2mm-chambered pinfire guns. The projectile is comparable in size to a small shotgun pellet, and pistols chambered for 2mm rounds are often carried on a keychain.
The lighter Mark I APSV shell was capable of penetrating 88 mm of armour at 450 m at a 30-degree angle of impact. [2] In 1942, US Ordnance tested the Littlejohn adaptor in an attempt to develop a taper bore adaptor for the 37 mm Gun M3. The adaptor distorted after a few shots. [3]
Sheridan Products Inc. was formed to produce Pneumatic Air Pellet Rifles with production beginning in March 1947. In the early 1940s Co-founder Ed Wackerhagen, dissatisfied with a pellet gun used by his son, set out to build one of the finest airguns in history.
Speer Gold Dot 124gr 9mm+P in SIG P226 magazines. Overpressure ammunition, commonly designated as +P or +P+ (pronounced Plus-P or Plus-P-Plus), is small arms ammunition that has been loaded to produce a higher internal pressure when fired than is standard for ammunition of its caliber (see internal ballistics), but less than the pressures generated by a proof round.
Cable 2/50 S (2.2 mm outer / 1 mm inner diameter) SSMB-Nano The SSMB-Nano connector is a small version of the standard SMB connector with a 'snap-on' coupling. ...
Later, M-80s were manufactured as consumer fireworks made from a small cardboard tube, often red, approximately 1 + 1 ⁄ 2 inches (3.8 cm) long and 9 ⁄ 16 inch (1.4 cm) inside diameter, with a fuse coming out of the side; this type of fuse is commonly known as cannon fuse or Visco fuse, after a company responsible for standardizing the product.
2.1 mm center pin Common on guitar effect pedals Arduino power adapter IEC 60130-10 Type A (first of two with same type and same OD, the other has ID of 2.5mm and center PIN) 5.50 2.10 CUI Inc. P10 Kobiconn 7391 Philmore 2560 Switchcraft 768K [8] 2.1 mm center pin, lock-ring: 5.50 2.10 Kobiconn 0721-EX Kobiconn 1000-EX (panel) 2.1 mm center pin ...
The 2.5 mm or sub-miniature sizes were similarly popularized on small portable electronics. They often appeared next to a 3.5 mm microphone jack for a remote control on-off switch on early portable tape recorders; the microphone provided with such machines had the on-off switch and used a two-pronged connector with both the 3.5 and 2.5 mm plugs.