Search results
Results from the WOW.Com Content Network
The Nintendo Wi-Fi USB Connector. The Nintendo Wi-Fi USB Connector is a wireless game adapter, developed by Nintendo and Buffalo Technology, which allows the Nintendo DS, Wii and 3DS users without a Wi-Fi connection or compatible Wi-Fi network to establish an Internet connection via a broadband-connected PC.
The eSATA connector is a more robust SATA connector, intended for connection to external hard drives and SSDs. eSATA's transfer rate (up to 6 Gbit/s) is similar to that of USB 3.0 (up to 5 Gbit/s) and USB 3.1 (up to 10 Gbit/s). A device connected by eSATA appears as an ordinary SATA device, giving both full performance and full compatibility ...
Micro-USB; due to Micro-USB power delivery limitations, powering over GPIO is suggested [4] [5] 5V/2.5~3A Micro USB (supports low power voltage detection) 12V - 19V DC-in barrel connector 12-19V via DC barrel power input jack (5.5/2.5 mm) 12-19V via DC barrel power input jack (5.5/2.5 mm) 1 x 4-Pin Power In Header (also for POE module) Form Factor
Micro-USB connectors, which were announced by the USB-IF on January 4, 2007, [15] [16] have a similar width to Mini-USB, but approximately half the thickness, enabling their integration into thinner portable devices. The Micro-A connector is 6.85 by 1.8 mm (0.270 by 0.071 in) with a maximum overmold boot size of 11.7 by 8.5 mm (0.46 by 0.33 in ...
The Game Boy Micro Wireless Adapter is functionally the same as the Game Boy Advance Wireless Adapter. The only difference between the two varieties is that the Game Boy Micro Wireless Adapter is made to fit the Game Boy Micro's smaller link cable port, and will therefore not fit other Game Boy models or the e-Reader.
With the introduction of the USB micro plug, a new plug receptacle called micro-AB was also introduced. It can accept either a micro-A plug or a micro-B plug. Micro-A adapters allow for connection to standard-A plugs, as used on fixed or standard devices. An OTG product must have a single micro-AB receptacle and no other USB receptacles. [5] [6]
A single SD/MMC card slot supporting SDIO, a USB On-The-Go port, an RS-232 serial connection, a JTAG connection, and two stereo 3.5 mm jacks for audio in/out are provided. Built-in storage and memory are provided through a PoP chip that includes 256 MB of NAND flash memory and 256 MB of RAM (128 MB on earlier models).
SATA is a computer bus interface for connecting host bus adapters to mass storage devices such as hard disk drives and optical drives. eSATA is a SATA connector accessible from outside the computer, to provide a signal (but not power) connection for external storage devices.