Search results
Results from the WOW.Com Content Network
What links here; Upload file; Special pages; Printable version; Page information
Square rig is a generic type of sail and rigging arrangement in which the primary driving sails are carried on horizontal spars which are perpendicular, or square, to the keel of the vessel and to the masts. These spars are called yards and their tips, outside the lifts, are called the yardarms. [1] A ship mainly rigged so is called a square ...
Rigging of a sailing frigate. A sailing vessel's rig is its arrangement of masts, sails and rigging. [1] Examples include a schooner rig, cutter rig, junk rig, etc. [2] A rig may be broadly categorized as "fore-and-aft", "square", or a combination of both. Within the fore-and-aft category there is a variety of triangular and quadrilateral sail ...
A sail plan is a drawing of a sailing craft, viewed from the side, depicting its sails, the spars that carry them and some of the rigging that supports the rig. [1] By extension, "sail plan" describes the arrangement of sails on a craft. [2] [3] A sailing craft may be waterborne (a ship or boat), an iceboat, or a sail-powered land vehicle.
A typical brig sail plan. In sailing, a full-rigged brig is a vessel with two square rigged masts (fore and main). [2] The main mast of a brig is the aft one. To improve maneuverability, the mainmast carries a (gaff rigged) fore-and-aft sail.
Clewlines and buntlines are lines used to handle the sails of a square rigged ship. The leechlines are clearly visible running inwards and upwards from the edges of the sail. The buntlines up the front of the sail can be seen too, but their run to the blocks on the shrouds is obscured because the sail is set on a lifting yard.
An illustration of a bilander Rig diagram. The bilander, also spelled billander or bélandre is a two-masted vessel, the foremast carrying square rigs on all of its yards and its taller mainmast having a long lateen mainsail yard with corresponding trapezoidal sail and rig inclined at about 45° with square rigs on the yards above that, the lowermost secured at the corners by a crossjack.
The lowest and normally largest sail on a mast is the course sail of that mast, and is referred to simply by the mast name: Foresail, mainsail, mizzen sail, jigger sail or more commonly forecourse etc. Even a full-rigged ship did not usually have a lateral (square) course on the mizzen mast below the mizzen topmast.