Ads
related to: uhf female impedance analyzer
Search results
Results from the WOW.Com Content Network
A typical SO-239 UHF female, properly hooded, has an impedance bump of about 35 ohms. The length of the bump is typically 1 ⁄ 2 inch, where the female pin flares to fit over the male pin. This bump can be mitigated by using a honeycomb dielectric in the female pin area. Many VHF/UHF amateur operators use special UHF females that maintain a 50 ...
An antenna analyzer measuring SWR and complex impedance of a dummy load. MFJ-269, MFJ Enterprises Inc. An antenna analyzer or in British aerial analyser (also known as a noise bridge, RX bridge, SWR analyzer, or RF analyzer) is a device used for measuring the input impedance of antenna systems in radio electronics applications.
An impedance analyzer is a type of electronic test equipment used to measure complex electrical impedance as a function of test frequency. Impedance is an important parameter used to characterize electronic components , electronic circuits , and the materials used to make components.
N connector "Type N" (Neill) 50 Ω or 75 Ω characteristic impedance connector (IEC 61169-16 [4]) NMD connector, standing for Network Measurements Division, are usually available as 3.5 mm, 2.9 mm, 2.4 mm, and 1.85 mm connectors. They are ruggedized test-port connectors used on test sets and network analyzers.
An SWR meter does not measure the actual impedance of a load (the resistance and reactance), but only the mismatch ratio. To measure the actual impedance requires an antenna analyzer or other similar RF measuring device. For accurate readings, the SWR meter itself must also match the line's impedance (typically 50 or 75 Ohms).
SWR is used as a measure of impedance matching of a load to the characteristic impedance of a transmission line carrying radio frequency (RF) signals. This especially applies to transmission lines connecting radio transmitters and receivers with their antennas, as well as similar uses of RF cables such as cable television connections to TV receivers and distribution amplifiers.
The APC-7 connector (also referred to as a 7 mm connector) is a precision coaxial connector used on laboratory microwave test equipment for frequencies up to 18 GHz.APC-7 connectors are advantageous because they have a low reflection coefficient, make repeatable coaxial connections, and are genderless. [1]
Type N connector (female) The N connector (also, type-N connector) is a threaded, weatherproof, medium-size RF connector used to join coaxial cables.It was one of the first connectors capable of carrying microwave-frequency signals, and was invented in the 1940s by Paul Neill of Bell Labs, after whom the connector is named.
Ads
related to: uhf female impedance analyzer