Search results
Results from the WOW.Com Content Network
A typical SO-239 UHF female, properly hooded, has an impedance bump of about 35 ohms. The length of the bump is typically 1 ⁄ 2 inch, where the female pin flares to fit over the male pin. This bump can be mitigated by using a honeycomb dielectric in the female pin area. Many VHF/UHF amateur operators use special UHF females that maintain a 50 ...
Stubs can match a load impedance to the transmission line characteristic impedance. The stub is positioned a distance from the load. This distance is chosen so that at that point, the resistive part of the load impedance is made equal to the resistive part of the characteristic impedance by impedance transformer action of the length of the main ...
N connector "Type N" (Neill) 50 Ω or 75 Ω characteristic impedance connector (IEC 61169-16 [4]) NMD connector, standing for Network Measurements Division, are usually available as 3.5 mm, 2.9 mm, 2.4 mm, and 1.85 mm connectors. They are ruggedized test-port connectors used on test sets and network analyzers.
Various popular RF connectors Electronic symbols for the plug and jack coaxial connectors Time-domain reflectometry shows reflections due to impedance variations in mated RF connectors. An RF connector (radio frequency connector) is an electrical connector designed to work at radio frequencies in the multi-megahertz range.
In electrical engineering, impedance is the opposition to alternating current presented by the combined effect of resistance and reactance in a circuit. [1]Quantitatively, the impedance of a two-terminal circuit element is the ratio of the complex representation of the sinusoidal voltage between its terminals, to the complex representation of the current flowing through it. [2]
Blackman's theorem is a general procedure for calculating the change in an impedance due to feedback in a circuit. It was published by Ralph Beebe Blackman in 1943, [1] was connected to signal-flow analysis by John Choma, and was made popular in the extra element theorem by R. D. Middlebrook and the asymptotic gain model of Solomon Rosenstark.
Type N connector (female) The N connector (also, type-N connector) is a threaded, weatherproof, medium-size RF connector used to join coaxial cables.It was one of the first connectors capable of carrying microwave-frequency signals, and was invented in the 1940s by Paul Neill of Bell Labs, after whom the connector is named.
When measuring with a field strength meter it is important to use a calibrated antenna such as the standard antenna supplied with the meter. For precision measurements the antenna must be at a standard height. A value of standard height frequently employed for VHF and UHF measurements is 10 metres (33 ft).