Search results
Results from the WOW.Com Content Network
In logical block addressing, only one number is used to address data, and each linear base address describes a single block. The LBA scheme replaces earlier schemes which exposed the physical details of the storage device to the software of the operating system. Chief among these was the cylinder-head-sector (CHS) scheme, where blocks were addressed by means
INT 13h is shorthand for BIOS interrupt call 13 hex, the 20th interrupt vector in an x86-based (IBM PC-descended) computer system.The BIOS typically sets up a real mode interrupt handler at this vector that provides sector-based hard disk and floppy disk read and write services using cylinder-head-sector (CHS) addressing.
Negative LBA addresses indicate a position from the end of the volume, with −1 being the last addressable block. The GUID Partition Table ( GPT ) is a standard for the layout of partition tables of a physical computer storage device , such as a hard disk drive or solid-state drive , using universally unique identifiers (UUIDs), which are also ...
An extended boot record (EBR), [1] or extended partition boot record (EPBR), [note 1] is a descriptor for a logical partition under the common DOS disk drive partitioning system. In that system, when one (and only one) partition record entry in the master boot record (MBR) is designated an extended partition , then that partition can be ...
Logical block addressing#LBA64 To a related topic : This is a redirect to an article about a similar topic. Redirects from related topics are different than redirects from related words, because a related topic is more likely to warrant a full and detailed description in the target article.
The address size used in logical block addressing was increased to 48 bits with the introduction of ATA-6. The Ext4 file system physically limits the file block count to 48 bits. The minimal implementation of the x86-64 architecture provides 48-bit addressing encoded into 64 bits; future versions of the architecture can expand this without ...
JDS—Java Desktop System; JFC—Java Foundation Classes; JFET—Junction Field-Effect Transistor; JFS—IBM Journaling File System; JINI—Jini Is Not Initials; JIT—Just-In-Time; JME—Java Micro Edition; JMX—Java Management Extensions; JMS—Java Message Service; JNDI—Java Naming and Directory Interface; JNI—Java Native Interface; JNZ ...
Relocation is the process of assigning load addresses for position-dependent code and data of a program and adjusting the code and data to reflect the assigned addresses. [1] [2] Prior to the advent of multiprocess systems, and still in many embedded systems, the addresses for objects are absolute starting at a known location, often zero.