Search results
Results from the WOW.Com Content Network
In 1929, the United States Shipping Board evaluated a pulverized coal-boiler on the steamship Mercer, a 9,500 ton merchant ship. According to its report, the boiler heated with pulverized coal on the Mercer ran at 95% of the efficiency of its best oil-fuelled journey. Firing pulverized coal was also cheaper to operate and install than ship ...
In 1929, a test boiler that had been built in 1927 began operating in the thermal power plant at Gartenfeld in Berlin for the first time in subcritical mode with a fully open throttle valve. The second Benson boiler began operation in 1930 without a pressurizing valve at pressures between 40 and 180 bar (4 and 18 MPa; 580 and 2,611 psi) at the ...
Diagram of a water-tube boiler. Another way to rapidly produce steam is to feed the water under pressure into a tube or tubes surrounded by the combustion gases. The earliest example of this was developed by Goldsworthy Gurney in the late 1820s for use in steam road carriages. This boiler was ultra-compact and light in weight and this ...
[5] [6] In the subcritical region, the phase transition is associated with an effective spike in the heat capacity (i.e., the latent heat). Approaching the critical point, the latent heat falls to zero but this is accompanied by a gradual rise in heat capacity in the pure phases near phase transition.
In the pressure-temperature phase diagram (Fig. 1) the boiling curve separates the gas and liquid region and ends in the critical point, where the liquid and gas phases disappear to become a single supercritical phase. The appearance of a single phase can also be observed in the density-pressure phase diagram for carbon dioxide (Fig. 2).
One example is the liquid–vapor critical point, the end point of the pressure–temperature curve that designates conditions under which a liquid and its vapor can coexist. At higher temperatures, the gas comes into a supercritical phase, and so cannot be liquefied by pressure alone.
Boiler design is the process of designing boilers used for various purposes. The main function of a boiler is to heat water to generate steam. Steam produced in a boiler can be used for a variety of purposes including space heating, sterilisation, drying, humidification and power generation. The temperature or condition of steam required for ...
Diagram of boiler feed water deaerator (with vertical, domed aeration section and horizontal water storage section). The water is usually pressurized in two stages, and typically flows through a series of six or seven intermediate feed water heaters, heated up at each point with steam extracted from an appropriate extraction connection on the ...