Search results
Results from the WOW.Com Content Network
Various sized cuts of 1 ⁄ 2 in (13 mm) drywall with tools for maintenance and installation . Drywall (also called plasterboard, dry lining, [1] wallboard, sheet rock, gib board, gypsum board, buster board, turtles board, slap board, custard board, gypsum panel and gyprock) is a panel made of calcium sulfate dihydrate (), with or without additives, typically extruded between thick sheets of ...
A gypsum block is made of gypsum plaster and water. The manufacturing process [1] is automated at production plants where raw gypsum (CaSO 4 ·2H 2 O) is ground and dried, then heated to remove three-quarters of the bound water and thus transformed into calcium sulfate hemihydrate (CaSO 4 ·½H 2 O), also known as gypsum plaster, stucco, calcined gypsum or plaster of Paris.
Gypsum board [36] is primarily used as a finish for walls and ceilings, and is known in construction as plasterboard, "sheetrock", or drywall. Gypsum provides a degree of fire-resistance to these materials, and glass fibers are added to their composition to accentuate this effect.
In the United States, the International Building Code and ASTM International define Exterior Insulation and Finish System (EIFS) as a non-load-bearing exterior wall cladding system that consists of an insulation board attached either adhesively, mechanically, or both, to the substrate; an integrally reinforced base coat; and a textured protective finish coat.
In use as early as 1900, rock lath (also known as "button board," "plaster board" or "gypsum-board lath"), is a type of gypsum wall board (essentially an early form of drywall) with holes spaced regularly to provide a 'key' for wet plaster. [3] Rock lath was typically produced in sheets sized 2 by 4 feet (610 by 1,220 mm).
It can be used on the exterior of buildings as a base for exterior plaster systems and sometimes as the finish system itself. Cement board adds impact resistance and strength to the wall surface as compared to water resistant gypsum boards. Cement board is also fabricated in thin sheets with polymer modified cements to allow bending for curved ...
It is chiefly made of plaster of Paris (powdered gypsum), with a little cement, glycerin, and dextrin, mixed with water until it is about as thick as molasses. When staff is cast in molds, it can form any shape. To strengthen it, coarse cloth or bagging, or fibers of hemp or jute, are put into the molds before casting. It becomes hard enough in ...
Plaster veneer (American English) or plaster skim (British English) is a construction methodology for surfacing interior walls, by applying a thin layer of plaster over a substrate—typically over specially formulated gypsum board base, similar in nature to drywall.