Search results
Results from the WOW.Com Content Network
In subsurface hydrogeology, drawdown is the reduction in hydraulic head observed at a well in an aquifer, typically due to pumping a well as part of an aquifer test or well test. In surface water hydrology and civil engineering , drawdown refers to the lowering of the surface elevation of a body of water, the water table, the piezometric ...
This cycle of soak-and-produce, or "huff-and-puff," may be repeated until the response becomes marginal because of declining natural reservoir pressure and increased water production. At this time a continuous steamflood is usually initiated to continue the heating and thinning of the oil and to replace declining reservoir pressure so that ...
A drill stem test (DST) is a procedure for isolating and testing the pressure, permeability and productive capacity of a geological formation during the drilling of a well. The test is an important measurement of pressure behaviour at the drill stem and is a valuable way of obtaining information on the formation fluid and establishing whether a ...
Simplified process flow diagram. A plant is receiving a multi phased flow of oil and gas from many wells via a manifold. Flow from one well only may be taken to the test separator (shaded). The test separator has the feature to separate gas and water from the oil, and to have each component measured, under different conditions.
The combination of the downward movement of the tubing and the upward movement of the fluid (or piston effect) results in an increase in pressure throughout the well. This increase in pressure is commonly called Surge pressure. Upward movement of the tubing (tripping out) also affects the pressure at the bottom of the well.
The data that PDGs provide are useful to reservoir engineers in determining the quantities of oil or gas contained below the Earth's surface in an oil or gas reservoir and also which method of production is best. [2] Permanent downhole gauges are installed in oil wells and gas wells for the purposes of observation and optimization. Downhole ...
An oil producing well is usually completed to pump all produced fluids to the surface where the fluids will be separated into their constituent components. In the early life of most oil producing wells, more petroleum will usually be produced than produced water. The produced water is considered to be wastewater that will need to be treated.
Pump pressure, which is also referred to as system pressure loss, is the sum total of all the pressure losses from the oil well surface equipment, the drill pipe, the drill collar, the drill bit, and annular friction losses around the drill collar and drill pipe. It measures the system pressure loss at the start of the circulating system and ...