Search results
Results from the WOW.Com Content Network
In thermodynamics, the compressibility factor (Z), also known as the compression factor or the gas deviation factor, describes the deviation of a real gas from ideal gas behaviour. It is simply defined as the ratio of the molar volume of a gas to the molar volume of an ideal gas at the same temperature and pressure .
The compressibility factor is defined as = where p is the pressure of the gas, T is its temperature, and is its molar volume, all measured independently of one another. In the case of an ideal gas, the compressibility factor Z is equal to unity, and the familiar ideal gas law is recovered:
According to van der Waals, the theorem of corresponding states (or principle/law of corresponding states) indicates that all fluids, when compared at the same reduced temperature and reduced pressure, have approximately the same compressibility factor and all deviate from ideal gas behavior to about the same degree. [1] [2]
compressibility effects; variable specific heat capacity; van der Waals forces; non-equilibrium thermodynamic effects; issues with molecular dissociation and elementary reactions with variable composition; For most applications, such a detailed analysis is unnecessary, and the ideal gas approximation can be used with reasonable accuracy.
In general, compressibility is defined as the relative volume change of a fluid or solid as a response to a pressure, and may be determined for substances in any phase. Similarly, thermal expansion is the tendency of matter to change in volume in response to a change in temperature.
The limiting oxygen concentration (LOC), [1] also known as the minimum oxygen concentration (MOC), [2] is defined as the limiting concentration of oxygen below which combustion is not possible, independent of the concentration of fuel. It is expressed in units of volume percent of oxygen. The LOC varies with pressure and temperature.
The general equation of state for a real gas is usually written as = = where the critical compressibility factor , which reflects the volumetric deviation of the real gases from the ideal gas, is also not easily accessible from laboratory experiments. However, critical pressure and critical temperature are more accessible from measurements.
The compressibility factor is a dimensionless quantity which is equal to 1 for ideal gases and deviates from unity for increasing levels of non-ideality. [ 9 ] Several non-ideal models exist, from the simplest cubic equations of state (such as the Van der Waals [ 4 ] [ 10 ] and the Peng-Robinson [ 11 ] models) up to complex multi-parameter ones ...