Search results
Results from the WOW.Com Content Network
In AmigaOS one can use the i2c.resource component [25] for AmigaOS 4.x and MorphOS 3.x or the shared library i2c.library by Wilhelm Noeker for older systems. Arduino developers can use the "Wire" library. CircuitPython and MicroPython developers can use the busio.I2C or machine.I2C classes respectively.
An electronic symbol is a pictogram used to represent various electrical and electronic devices or functions, such as wires, batteries, resistors, and transistors, in a schematic diagram of an electrical or electronic circuit. These symbols are largely standardized internationally today, but may vary from country to country, or engineering ...
A circuit diagram (or: wiring diagram, electrical diagram, elementary diagram, electronic schematic) is a graphical representation of an electrical circuit. A pictorial circuit diagram uses simple images of components, while a schematic diagram shows the components and interconnections of the circuit using standardized symbolic representations.
Schematic symbol for a buffer with open-collector output [6] Open output is indicated on schematics with these IEEE symbols: [7] ⎐ – NPN open collector or similar output that can supply a relatively low-impedance low voltage when not turned off. Requires external pullup. Capable of positive-logic wired-AND connection.
In circuit diagrams and circuit analysis, there are long-standing conventions regarding the naming of voltages, currents, and some components. [5] In the analysis of a bipolar junction transistor, for example, in a common-emitter configuration, the DC voltage at the collector, emitter, and base (with respect to ground) may be written as V C , V ...
A reference designator unambiguously identifies the location of a component within an electrical schematic or on a printed circuit board.The reference designator usually consists of one or two letters followed by a number, e.g. C3, D1, R4, U15.
Vcc Vcc Type 4 DIR EN SenseA SenseB GND Vcc Type 5 (dual H-bridge) DIR1 EN1 DIR2 EN2 GND Vcc Type 5A (extended dual H-bridge) DIR1 DIR2 EN1 EN2 Sense1A Sense2A Sense1B Sense2B GND GND Vcc Vcc Type 6 nc/INT nc/RESET SCL SDA GND Vcc Type 6A (extended I2C) nc/INT GPIO nc/RESET GPIO SCL GPIO SDA GPIO GND GND Vcc Vcc Type 7 LRCLK GPIO DACdata
The mutual goal of IEEE Std 91-1984 and IEC 617-12 was to provide a uniform method of describing the complex logic functions of digital circuits with schematic symbols. These functions were more complex than simple AND and OR gates. They could be medium-scale circuits such as a 4-bit counter to a large-scale circuit such as a microprocessor.