Search results
Results from the WOW.Com Content Network
The detection of a RESET signal causes the processor to enter a system initialization period of six clock cycles, after which it sets the interrupt request disable flag in the status register and loads the program counter with the values stored at the processor initialization vector ($00FFFC – $00FFFD) before commencing execution. [1]
The Interrupt flag (IF) is a flag bit in the CPU's FLAGS register, which determines whether or not the (CPU) will respond immediately to maskable hardware interrupts. [1] If the flag is set to 1 maskable interrupts are enabled. If reset (set to 0) such interrupts will be disabled until
FLAGS registers can be moved from or to the stack. This is part of the job of saving and restoring CPU context, against a routine such as an interrupt service routine whose changes to registers should not be seen by the calling code. Here are the relevant instructions: The PUSHF and POPF instructions transfer the 16-bit FLAGS register.
What causes the bug is not an interrupt mask, nor are interrupts being explicitly disabled. Instead, an anomaly in the Cyrix's instruction pipeline prevents interrupts from being serviced for the duration of the loop; since the loop never ends, interrupts will never be serviced.
Clock-comparator subclass mask 0 21 CPU-timer subclass mask 0 22 Service-signal subclass mask 0 24 Set to 1 0 25 Interrupt-key subclass mask 0 26 Set to 1 0 27 ETR subclass mask 0 28 Program-call-fast 0 29 Crypto control 1 0 Primary space-switch-event control 1 1-19 Primary segment-table origin 1 22 Primary subspace-group control 1 23
With regard to SPARC, the non-maskable interrupt (NMI), despite having the highest priority among interrupts, can be prevented from occurring through the use of an interrupt mask. [1] An NMI is often used when response time is critical or when an interrupt should never be disabled during normal system operation.
Causes an interrupt when zero. rT, the trap address register Used to store the address of the trip vector. rTT, the dynamic trap address register Used to store the address of the trap vector. rK, the interrupt mask register Used to enable and disable specific interrupts. rQ, the interrupt request register Used to record interrupts as they occur.
In computer systems programming, an interrupt handler, also known as an interrupt service routine or ISR, is a special block of code associated with a specific interrupt condition. Interrupt handlers are initiated by hardware interrupts, software interrupt instructions, or software exceptions , and are used for implementing device drivers or ...