enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Wheel sizing - Wikipedia

   en.wikipedia.org/wiki/Wheel_sizing

   The bolt circle diameter is typically expressed in mm and accompanies the number of bolts in your vehicle's bolt pattern. One example of a common bolt pattern is 5x100 mm. This means there are 5 bolts evenly spaced about a 100 mm bolt circle. The picture to the right is an example of a 5×100 mm bolt pattern on a Subaru BRZ. The wheel has 5 lug ...

3. List of GM bellhousing patterns - Wikipedia

   en.wikipedia.org/.../List_of_GM_bellhousing_patterns

   The 2.2l S10/Sonoma had the starter located in the same position as front wheel drive cars. A rear wheel drive bellhousing is displayed at right, and the integrated front wheel drive bellhousing is displayed at the lower right (in this case, as a part of the GM 6T70 Transmission). GM 60-Degree 2.8/3.1/3.4/3.5/3.9 L V6 (also used by AMC) Buick ...

4. TorqueFlite - Wikipedia

   en.wikipedia.org/wiki/TorqueFlite

   Compared to the early cast-iron transmissions, many and various internal improvements were featured, and it used a 10.75 in (27.3 cm) or 11.75 in (29.8 cm) torque converter. The heavier-duty A727 Torqueflites became — and remain — wildly popular for drag racing , off roading , and monster truck applications because of their controllability ...

5. Lug nut - Wikipedia

   en.wikipedia.org/wiki/Lug_nut

   The conical lug's taper is normally 60 degrees (although 45 degrees is common for wheels designed for racing applications), and is designed to help center the wheel accurately on the axle, and to reduce the tendency for the nut to loosen due to fretting induced precession, as the car is driven. One popular alternative to the conical lug seating ...

6. Chevrolet small-block engine (first- and second-generation)

   en.wikipedia.org/wiki/Chevrolet_small-block...

   The large-journal connecting rods were thicker (heavier) and used 3 ⁄ 8 in (9.5 mm) diameter cap-bolts to replace the small-journal's 11/32. 1968 blocks were made in 2-bolt and 4-bolt versions with the 4-bolt center-three main caps each fastened by two additional bolts which were supported by the addition of thicker crankcase main-web bulkheads.

7. Get ready for sky-high 'new traffic pattern' from I-75 to I-74

   www.aol.com/ready-sky-high-traffic-pattern...

   Replacement of Seymour Avenue bridge and reconstruction of parts of Paddock Road bridge over I-75 in preparation for other coming improvements, for $7.6 million.