enow.com Web Search

Search results

  1. Results from the WOW.Com Content Network
  2. Drainage gradient - Wikipedia

    en.wikipedia.org/wiki/Drainage_gradient

    Drainage gradient (DG) is a term in road design, defined as the combined slope due to road surface cross slope (CS) and longitudinal slope (hilliness). Although the term may not be used, the concept is also used in roof design and landscape architecture. If the drainage gradient is too low, rain and melt water drainage will be insufficient.

  3. Invert level - Wikipedia

    en.wikipedia.org/wiki/Invert_level

    Invert level affects flow from drainage pipes In civil engineering , the invert level is the base interior level of a pipe, trench or tunnel ; it can be considered the "floor" level. [ 1 ] The invert is an important datum for determining the functioning or flowline of a piping system.

  4. International Plumbing Code - Wikipedia

    en.wikipedia.org/wiki/International_Plumbing_Code

    The IPC is the most widely used plumbing code in the United States and is also used as the basis for the plumbing code of several other countries [citation needed].Wide adoptions are important as they help reduce manufacturer and end-user costs by allowing the use of materials across a wide user base, thus allowing economies of scale in the production of materials used in construction.

  5. Cross slope - Wikipedia

    en.wikipedia.org/wiki/Cross_slope

    Cross slope, cross fall or camber is a geometric feature of pavement surfaces: the transverse slope with respect to the horizon. It is a very important safety factor. Cross slope is provided to provide a drainage gradient so that water will run off the surface to a drainage system such as a street gutter or ditch.

  6. Uniform Plumbing Code - Wikipedia

    en.wikipedia.org/wiki/Uniform_Plumbing_Code

    Section 3 does not allow any construction approval of the Inspector of Plumbing and Drainage. A written description of the proposed work is to be submitted in advance to the inspector for his approval. Section 16 mandates the use of cast iron for interior pipes and Section 12 mandates the use of "vitrified stone ware pipes" that "run under ...

  7. Drainage equation - Wikipedia

    en.wikipedia.org/wiki/Drainage_equation

    the design drain spacing (L) can be found from the equation in dependence of the drain depth (Dd) and drain radius (r). Drainage criteria One would not want the water table to be too shallow to avoid crop yield depression nor too deep to avoid drought conditions. This is a subject of drainage research.

  8. French drain - Wikipedia

    en.wikipedia.org/wiki/French_drain

    A pipe might become overfilled if it is on a side of the drain which receives a much larger volume of water, such as one pipe being closer to an uphill slope, or closer to a roofline that drips near the French drain. When a pipe becomes overfilled, water can seep sideways into a parallel pipe, as a form of load-balancing, so that neither pipe ...

  9. Drain-waste-vent system - Wikipedia

    en.wikipedia.org/wiki/Drain-waste-vent_system

    A sewer pipe is normally at neutral air pressure compared to the surrounding atmosphere.When a column of waste water flows through a pipe, it compresses air ahead of it in the system, creating a positive pressure that must be released so it does not push back on the waste stream and downstream traps, slow drainage, and induce potential clogs.