Search results
Results from the WOW.Com Content Network
Data transfer is initiated with a start condition (S) signalled by SDA being pulled low while SCL stays high. SCL is pulled low, and SDA sets the first data bit level while keeping SCL low (during blue bar time). The data is sampled (received) when SCL rises for the first bit (B1).
The first data bit is output immediately when CS activates. Subsequent bits are output when SCLK transitions to its idle voltage level. Sampling occurs when SCLK transitions from its idle voltage level. For CPHA=1: The first data bit is output on SCLK's first clock edge after CS activates.
The figures below are simplex data rates, which may conflict with the duplex rates vendors sometimes use in promotional materials. Where two values are listed, the first value is the downstream rate and the second value is the upstream rate. The use of decimal prefixes is standard in data communications.
It carries clock, data, and instructions and is based on Philips' I²C serial bus protocol. [1] Its clock frequency range is 10 kHz to 100 kHz. (PMBus extends this to 400 kHz.) Its voltage levels and timings are more strictly defined than those of I²C, but devices belonging to the two systems are often successfully mixed on the same bus.
Between data frames, the bus controller holds SCL high, in effect stopping the clock, and SDA drivers are in a high-impedance state, permitting a pull-up resistor to float it to high. A high-to-low transition of SDA while SCL is high is known as a START symbol, and signals the beginning a new data frame.
Asynchronous start-stop is the lower data-link layer used to connect computers to modems for many dial-up Internet access applications, using a second (encapsulating) data link framing protocol such as PPP to create packets made up out of asynchronous serial characters. The most common physical layer interface used is RS-232D.
The search engine that helps you find exactly what you're looking for. Find the most relevant information, video, images, and answers from all across the Web.
Synchronous Serial Interface (SSI) is a widely used serial interface standard for industrial applications between a master (e.g. controller) and a slave (e.g. sensor). SSI is based on RS-422 [1] standards and has a high protocol efficiency in addition to its implementation over various hardware platforms, making it very popular among sensor manufacturers.