enow.com Web Search

Search results

  1. Results from the WOW.Com Content Network
  2. Saline water - Wikipedia

    en.wikipedia.org/wiki/Saline_water

    At 20 °C (68 °F) one liter of water can dissolve about 357 grams of salt, a concentration of 26.3 percent by weight (% w/w). At 100 °C (212 °F) (the boiling temperature of pure water), the amount of salt that can be dissolved in one liter of water increases to about 391 grams, a concentration of 28.1% w/w.

  3. Properties of water - Wikipedia

    en.wikipedia.org/wiki/Properties_of_water

    However, the salt content of oceans lowers the freezing point by about 1.9 °C [41] (due to freezing-point depression of a solvent containing a solute) and lowers the temperature of the density maximum of water to the former freezing point at 0 °C.

  4. Seawater - Wikipedia

    en.wikipedia.org/wiki/Seawater

    The average density at the surface is 1.025 kg/L. Seawater is denser than both fresh water and pure water (density 1.0 kg/L at 4 °C (39 °F)) because the dissolved salts increase the mass by a larger proportion than the volume. The freezing point of seawater decreases as salt concentration increases.

  5. Brine - Wikipedia

    en.wikipedia.org/wiki/Brine

    Brine (or briny water) is water with a high-concentration solution of salt (typically sodium chloride or calcium chloride).In diverse contexts, brine may refer to the salt solutions ranging from about 3.5% (a typical concentration of seawater, on the lower end of that of solutions used for brining foods) up to about 26% (a typical saturated solution, depending on temperature).

  6. Sodium chloride - Wikipedia

    en.wikipedia.org/wiki/Sodium_chloride

    In the technical terms of physical chemistry, the minimum freezing point of a water-salt mixture is −21.12 °C (−6.02 °F) for 23.31 wt% of salt. Freezing near this concentration is however so slow that the eutectic point of −22.4 °C (−8.3 °F) can be reached with about 25 wt% of salt. [13]

  7. Table of specific heat capacities - Wikipedia

    en.wikipedia.org/wiki/Table_of_specific_heat...

    A Assuming an altitude of 194 metres above mean sea level (the worldwide median altitude of human habitation), an indoor temperature of 23 °C, a dewpoint of 9 °C (40.85% relative humidity), and 760 mmHg sea level–corrected barometric pressure (molar water vapor content = 1.16%). B Calculated values *Derived data by calculation.

  8. Water (data page) - Wikipedia

    en.wikipedia.org/wiki/Water_(data_page)

    The values were not computed according formulas widely used in the US, but using somewhat more exact formulas (see below), which can also be used to compute further values in the appropriate temperature ranges. The saturated vapor pressure over water in the temperature range of −100 °C to −50 °C is only extrapolated [Translator's note ...

  9. Brine rejection - Wikipedia

    en.wikipedia.org/wiki/Brine_rejection

    The water underneath becomes saltier and colder, leading to an increase in density. This parcel of water in the Okhotsk Sea is referred to as dense shelf water (DSW). The saltier and colder a water parcel is, the denser it becomes, causing it to sink below other parcels of water. For this reason, the DSW will begin to sink within the water column.