Search results
Results from the WOW.Com Content Network
The vertical stabilizer is the fixed vertical surface of the empennage. A vertical stabilizer or tail fin [1] [2] is the static part of the vertical tail of an aircraft. [1] The term is commonly applied to the assembly of both this fixed surface and one or more movable rudders hinged to it. Their role is to provide control, stability and trim ...
The rudder is usually attached to the fin (or vertical stabilizer), which allows the pilot to control yaw about the vertical axis, i.e., change the horizontal direction in which the nose is pointing. Unlike a ship, both aileron and rudder controls are used together to turn an aircraft, with the ailerons imparting roll and the rudder imparting ...
A Boeing 737 uses an adjustable stabilizer, moved by a jackscrew, to provide the required pitch trim forces. Generic stabilizer illustrated. A horizontal stabilizer is used to maintain the aircraft in longitudinal balance, or trim: [3] it exerts a vertical force at a distance so the summation of pitch moments about the center of gravity is zero. [4]
The rudder is typically mounted on the trailing edge of the vertical stabilizer, part of the empennage. When the pilot pushes the left pedal, the rudder deflects left. Pushing the right pedal causes the rudder to deflect right. Deflecting the rudder right pushes the tail left and causes the nose to yaw to the right.
A twin-tailed B-25 Mitchell in flight. A twin tail is a type of vertical stabilizer arrangement found on the empennage of some aircraft.Two vertical stabilizers—often smaller on their own than a single conventional tail would be—are mounted at the outside of the aircraft's horizontal stabilizer.
Loss of vertical stabilizer 1963-01-30 1963 B-52 crash in New Mexico USA: New Mexico: B-52 Stratofortress: Unknowingly exceeded design capability 2 Near Mora: [7] loss of vertical stabilizer [8] 1964-01-04 1964 B-57 crash USA: Dayton: NRB-57 Canberra: Mis-management of fuel system, causing CofG to be beyond its safe rearward limit 2 Both wings ...
The V-tail or vee-tail (sometimes called a butterfly tail [1] or Rudlicki's V-tail [2] [citation needed]) of an aircraft is an unconventional arrangement of the tail control surfaces that replaces the traditional vertical and horizontal surfaces with two surfaces set in a V-shaped configuration. It is not widely used in aircraft design.
Examples of sideforce-generating surfaces are the vertical stabilizer, rudder, and parts of the fuselage. When an aircraft is in a sideslip, these surfaces generate sidewards lift forces. If the surface is above or below the center of gravity, the sidewards forces generate a rolling moment. This rolling moment caused by sideslip is dihedral ...