Ads
related to: how to replace guitar neck
Search results
Results from the WOW.Com Content Network
Neck-through construction is significantly harder to mass-produce than bolt-on or set-in neck constructions. As such, guitars with this construction method tend to be more expensive than guitars made by other methods. This method of construction may be somewhat more common in basses than in guitars. Repairs to the neck are usually expensive and ...
A pocket in the instrument's body for insertion of neck, as in bolt-on method. However, the pocket is much deeper than usual one. Long neck plank, comparable to the scale length, as in the neck-through method. Glueing (setting) the long neck inside the deep pocket, as in the set-neck method.
With hollow body set-in neck electric guitars of the 1940s being rather expensive to buy and repair, newcomer Fender in 1950 introduced electric guitars that were easier to manufacture, combining a simple solid body with a bolt-on neck. Fender also introduced the electric bass guitar by adding a longer neck bolted to a solid guitar body.
One particular example of a bolt-on neck using an actual bolt is Brian May's homemade Red Special, which uses a single bolt held in place by the guitar's truss rod and secured with a nut on the rear of the body. [3] An acoustic guitar bolt-on neck popularized by Taylor Guitars includes threaded inserts in the heel of the neck. Bolts inserted ...
The rigidity of the neck with respect to the body of the guitar is one determinant of an instrument's quality. Conversely, the ability to change the pitch of the note slightly by deliberately bending the neck forcibly with the fretting arm is a technique occasionally used, particularly in the blues genre and those derived from it, such as rock ...
Truss rods are frequently made out of steel, though graphite and other materials are sometimes used.. The truss rod can be adjusted to compensate for expansion or contraction in the neck wood due to changes in humidity or temperature, or to compensate for changes in the tension of the strings (the thicker the guitar string, the higher its tension when tuned to correct pitch) or using different ...
Often the edges of the guitar around the neck and body and down the middle of the back are inlaid. Skunk stripe inlay. Because some electric guitars (like the Fender Telecaster and Stratocaster) do not have a separate fretboard under which they can fit a truss rod, they fit it in the back of the neck and cover it with a strip of dark wood. This ...
Archtop guitars originally had two near-horizontal braces or "tone bars" on either side from bridge to neck, a system known as parallel bracing. The braces roughly run under the feet of the archtop guitar's bridge. X-bracing, similar to that of flat-top guitars was later introduced.
Ads
related to: how to replace guitar neck