Search results
Results from the WOW.Com Content Network
The coefficient of permeability varies with the void ratio as e/sup>/(1+e). For a given soil, the greater the void ratio, the higher the value of the coefficient of permeability. Here 'e' is the void ratio. Based on other concepts it has been established that the permeability of a soil varies as e 2 or e 3 /(1+e). Whatever may be the exact ...
The van test is used to determine the shear strength of a soil - material with coarse silt or sand can mean unreliable results. Permeability is found by determining whether the relevant aquifer is confined on unconfined with cognizance of the normal fluctuations in the aquifer. Installation of the borehole itself may influence stresses.
A practical unit for permeability is the darcy (d), or more commonly the millidarcy (md) (1 d ≈ 10 −12 m 2). The name honors the French Engineer Henry Darcy who first described the flow of water through sand filters for potable water supply. Permeability values for most materials commonly range typically from a fraction to several thousand ...
The activity of soil is the ratio of the plasticity index to the clay size fraction. If activity is less than 0.75, the soil is inactive. If activity exceeds 1.4, then the soil is termed active. If activity lies within the above values, then the soil will be moderately active. [10]
Soil bulk density, when determined at standardized moisture conditions, is an estimate of soil compaction. [3] Soil porosity consists of the void part of the soil volume and is occupied by gases or water. Soil consistency is the ability of soil materials to stick together. Soil temperature and colour are self-defining.
The opposite situation, i. e. when the void ratio is relatively small (dense soils), indicates that the volume of the soil is vulnerable to increase (swelling) under unloading – the smectite (montmorillonite, bentonite) partially dry clay particles present in an unsaturated soil can swell due to their hydration after contact with water (when ...
In geotechnical engineering, a soil test can be used to determine the physical characteristics of a soil, such as its water content, void ratio or bulk density. Soil testing can also provide information related to the shear strength, rate of consolidation and permeability of the soil. The following is a non-exhaustive list of engineering soil ...
The original Proctor test, ASTM D698 / AASHTO T99, uses a 4-inch-diameter (100 mm) by 4.584-inch-high (116.4 mm) mold which holds 1/30 cubic feet of soil, and calls for compaction of three separate lifts of soil using 25 blows by a 5.5 lb hammer falling 12 inches, for a compactive effort of 12,375 ft-lbf/ft 3.