enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. 2.5GBASE-T and 5GBASE-T - Wikipedia

   en.wikipedia.org/wiki/2.5GBASE-T_and_5GBASE-T

   By reducing the original signal rate to 1 ⁄ 4 or 1 ⁄ 2, the link speed drops to 2.5 or 5 Gbit/s, respectively. [5] The spectral bandwidth of the signal is reduced accordingly, lowering the requirements on the cabling, so that 2.5GBASE-T and 5GBASE-T can be deployed at a cable length of up to 100 m on Cat 5e or better cables. [6] [7]

3. Category 5 cable - Wikipedia

   en.wikipedia.org/wiki/Category_5_cable

   Cross section of a cat 5e cable. The Category 5e specification improves upon the Category 5 specification by further mitigating crosstalk. [9] The bandwidth (100 MHz) and physical construction are the same between the two, [10] and most Cat 5 cables actually happen to meet Cat 5e specifications even though they are not certified as such. [11]

4. Gigabit Ethernet - Wikipedia

   en.wikipedia.org/wiki/Gigabit_Ethernet

   Each 1000BASE-T network segment is recommended to be a maximum length of 100 meters (330 feet), [5] [a] and must use Category 5 cable or better (including Cat 5e and Cat 6). Autonegotiation is a requirement for using 1000BASE-T [ 6 ] according to Section 28D.5 Extensions required for Clause40 (1000BASE-T) . [ 7 ]

5. EtherCON - Wikipedia

   en.wikipedia.org/wiki/EtherCON

   The chassis connector is always female and has the standard form factor of an XLR panel connector. The chassis connector may be mated with an EtherCON connector and a standard 8P8C plug. The chassis connectors are rated for either Cat 5e, Cat 6 or 6A compatibility, with the Cat 5e and 6A models being cross-compatible. (The Cat 6 model utilizes ...

6. HDBaseT - Wikipedia

   en.wikipedia.org/wiki/HDBaseT

   HDBaseT connectors at a presentation and collaboration system from WolfVision. HDBaseT is a consumer electronic (CE) and commercial connectivity standard for transmission of uncompressed ultra-high-definition video, digital audio, DC power, Ethernet, USB 2.0, and other control communication (such as RS-232 and Consumer IR) over a single category cable (Cat 5e or better) up to 100 m (328 ft) in ...

7. Ethernet physical layer - Wikipedia

   en.wikipedia.org/wiki/Ethernet_physical_layer

   Generally, layers are named by their specifications: [8] 10, 100, 1000, 10G, ... – the nominal, usable speed at the top of the physical layer (no suffix = megabit/s, G = gigabit/s), excluding line codes but including other physical layer overhead (preamble, SFD, IPG); some WAN PHYs (W) run at slightly reduced bitrates for compatibility reasons; encoded PHY sublayers usually run at higher ...

8. Structured cabling - Wikipedia

   en.wikipedia.org/wiki/Structured_cabling

   Regardless of copper cable type (Cat 5e/6/6A), the maximum distance is 90 m for the permanent link installation, plus an allowance for a combined 10 m of patch cords at the ends. Cat 5e and Cat 6 can both effectively run power over Ethernet (PoE) applications up to 90 m. However, due to greater power dissipation in Cat 5e cable, performance and ...

9. 25 Gigabit Ethernet - Wikipedia

   en.wikipedia.org/wiki/25_Gigabit_Ethernet

   Direct attach SFP28-to-SFP28 copper cables in 1-, 2-, 3- and 5-meter lengths are available from several manufacturers, and optical transceiver manufacturers have announced 1310 nm "LR" optics intended for reach distances of 2 to 10 km over two strands of standard single-mode fiber, similar to existing 10GBASE-LR optics, as well as 850 nm "SR ...