Search results
Results from the WOW.Com Content Network
This can give information about the distribution of axles. For example, provide manufacturers the chassis configuration 8×4×4 to show that the vehicle has two steered front axles and two driven rear axles, compared to the chassis configuration 8×4/4 where the vehicle has one steered front axle, one steered rear axle (the fore axle) and two ...
In automobiles (and other wheeled vehicles which have two wheels on an axle), the axle track is the distance between the hub flanges on an axle. [1] Wheel track, track width or simply track refers to the distance between the centerline of two wheels on the same axle. In the case of an axle with dual wheels, the centerline of the dual wheel ...
A hubometer (from hub, center of a wheel; -ometer, measure of) or hubodometer, is a device mounted on the axle of any land vehicle to measure the distance traveled by a vehicle based on the rotations of the wheel hub. The whole device rotates with the wheel, except for an eccentrically mounted weight on an internal shaft.
Fifth Wheel towables are trailers that are designed to connect to the towing vehicle between the front and rear axles. Usually these are towed by pickup trucks and the fifth wheel receiver is placed in the bed of the truck. These Holiday Rambler towables can carry as much as 70 US gallons (260 L) of water.
The vehicle will then ride lower. The amount the vehicle sinks will depend on counter acting forces, like the size of the tires, tire pressure, and the spring rate of the suspension. If the vehicle is accelerating or decelerating, extra torque is placed on the rear or front tire respectively. The equation relating the wheelbase, height above ...
Wheels with Asanti 28 in (710 mm) rims on a police Hummer H2 car. The wheel size is the size designation of a wheel given by its diameter, width, and offset. The diameter of the wheel is the diameter of the cylindrical surface on which the tire bead rides. The width is the inside distance between the bead seat faces.
Clincher tires can be mounted on straight-side or crochet-type rims. Crochet-type rims are not the same as hooked-bead rims. Such tires are designated with their nominal section width and their nominal rim diameter, separated by a hyphen (-). Both are measured in millimeters. A typical example of a tire marking according to ISO 5775-1 is:
Performance vehicles may run zero front toe or even some toe-out for a better response to steering inputs. Increased front toe-in marginally increases the wear on the tires as the tires are under slight side slip conditions when the steering is set straight ahead. On front-wheel drive vehicles, the situation is more complex. Rear toe-in ...