Search results
Results from the WOW.Com Content Network
When packets are sent over a network, the destination IP address is examined. If the destination IP is outside of the network, then the packet goes to the gateway for transmission outside of the network. The gateway is on the same network as end devices. The gateway address must have the same subnet mask as host devices. Each host on the ...
The Cisco multicast router AUTO-RP-ANNOUNCE address is used by RP mapping agents to listen for candidate announcements. Yes 224.0.1.40 The Cisco multicast router AUTO-RP-DISCOVERY address is the destination address for messages from the RP mapping agent to discover candidates. Yes 224.0.1.41 H.323 Gatekeeper discovery address Yes 224.0.1.129–132
The IP-address could be 91.198.174.2. In this example, none of the internal routers know the route to that host, so they will forward the packet through router1's gateway or default route. [1] Every router on the packet's way to the destination will check whether the packet's destination IP-address matches any known network routes.
network identifier: The destination subnet and netmask; metric: The routing metric of the path through which the packet is to be sent. The route will go in the direction of the gateway with the lowest metric. next hop: The next hop, or gateway, is the address of the next station to which the packet is to be sent on the way to its final destination
A broadcast address is a network address used to transmit to all devices connected to a multiple-access communications network. A message sent to a broadcast address may be received by all network-attached hosts. In contrast, a multicast address is used to address a specific group of devices, and a unicast address is used to address a single ...
Ethernet packet. The SFD (start frame delimiter) marks the end of the packet preamble. It is immediately followed by the Ethernet frame, which starts with the destination MAC address. [1] In computer networking, an Ethernet frame is a data link layer protocol data unit and uses the underlying Ethernet physical layer transport mechanisms.
Destination network address translation (DNAT) is a technique for transparently changing the destination IP address of a routed packet and performing the inverse function for any replies. Any router situated between two endpoints can perform this transformation of the packet.
The Internet Engineering Task Force (IETF) has reserved the IPv4 address block 169.254.0.0 / 16 (169.254.0.0 – 169.254.255.255) for link-local addressing. [1] The entire range may be used for this purpose, except for the first 256 and last 256 addresses (169.254.0.0 / 24 and 169.254.255.0 / 24), which are reserved for future use and must not be selected by a host using this dynamic ...