Search results
Results from the WOW.Com Content Network
The Dana/Spicer Model 44 is an automotive axle manufactured by Dana Holding Corporation and is used extensively among automobile manufacturers and in the automotive aftermarket area as well. The Dana 44 was first manufactured in the 1940s [ 1 ] and is still being manufactured today, both front and rear axle variants.
Its GMC counterpart was the GMC New Design. It was billed as a larger, stronger, and sleeker design in comparison to the earlier AK Series . First available on Saturday, June 28, 1947, these trucks were sold with various minor changes over the years [ 3 ] until March 25, 1955, when the Task Force Series trucks replaced the Advance-Design model.
GM created the model PD-4102 by restyling its PD-4101 in 1950 using a distinctive new front end with the destination sign below the windshield and a new, restyled rear end which used a full-width engine access door, an aluminum alloy bumper to match that on the front and a "post-less" picture window in the rear which used biradial curved glass ...
Gross Axle Weight Rating (GAWR) 6500 lbs (full float, rear axle) 5500 lbs (semi float) GAWR is vehicle axle weight plus rated payload capacity; Ring gear diameter: 9 3 ⁄ 4 " Axle shaft diameter 1.41” Front (32 spline) 1.46” Rear (32 spline) 1.50” Front (35 spline) 1.50” Rear (35 spline) Inner axle shaft splines: 16, 23, 30, 32, 33 or 35
The Chevrolet AK Series is a range of pickup trucks sold under the Chevrolet brand, produced from 1941 through 1947. It used the GM A platform , shared with the Chevrolet Deluxe . The AK series was also branded and sold at GMC locations, with the primary visual difference being the Chevrolet had vertical bars in the grille, while the GMC had ...
The GMC Motorhome is a recreational vehicle that was manufactured by the GMC Truck & Coach Division of General Motors for model years 1973–1978 in Pontiac, Michigan, USA — as the only complete motorhome built by a major auto/truck manufacturer. Manufactured in 23 and 26 ft (7.0 and 7.9 m) lengths, the design was noted for its front-wheel ...
The 301.6-cubic-inch (4.9 L) GMC inline six was produced from 1952 to 1960, when it was replaced by the V6. It has a square bore/stroke ratio of 4 by 4 inches (101.6 mm × 101.6 mm). This is the largest raised-deck engine. It was originally designed for the GMC military M135 and M211.
GM began making 4x4 Chevrolet Kodiaks and GMC Topkicks that utilize a Dana 70 front axle for the 2005-2009 models. These Dana 70 axles had open knuckles and ball joints . The Dana 70 axle only came with 5.13:1, 4.88,5.31 [ citation needed ] gear ratios and had a GAWR of [ citation needed ] these axles were rated at 7-9klbs as seen on 5500 door ...