Search results
Results from the WOW.Com Content Network
Standard cubic centimeters per minute (SCCM) is a unit used to quantify the flow rate of a fluid. 1 SCCM is identical to 1 cm³ STP /min. Another expression of it would be Nml/min. Another expression of it would be Nml/min.
The meter is "read" as a differential pressure head in centimeters or inches of water. The venturi meter and manometer is a common type of flow meter which can be used in many fluid applications to convert differential pressure heads into volumetric flow rate, linear fluid speed, or mass flow rate using Bernoulli's principle.
A centimetre of water [1] is a unit of pressure. It may be defined as the pressure exerted by a column of water of 1 cm in height at 4 °C (temperature of maximum density) at the standard acceleration of gravity, so that 1 cmH 2 O (4°C) = 999.9720 kg/m 3 × 9.80665 m/s 2 × 1 cm = 98.063754138 Pa ≈ 98.0638 Pa, but conventionally a nominal maximum water density of 1000 kg/m 3 is used, giving ...
The CGS unit of pressure is the barye (Ba), equal to 1 dyn·cm −2, or 0.1 Pa. Pressure is sometimes expressed in grams-force or kilograms-force per square centimetre ("g/cm 2" or "kg/cm 2") and the like without properly identifying the force units. But using the names kilogram, gram, kilogram-force, or gram-force (or their symbols) as units ...
For example, for a typical steel alloy, K = 170 GPa, G = 80 GPa and p = 7700 kg/m 3, yielding a compressional speed c solid,p of 6,000 m/s. [11] This is in reasonable agreement with c solid,p measured experimentally at 5,930 m/s for a (possibly different) type of steel. [21] The shear speed c solid,s is estimated at 3,200 m/s using the same ...
In the cases where non-SI units are used, the numerical calculation of a formula can be done by first working out the factor, and then plug in the numerical values of the given/known quantities. For example, in the study of Bose–Einstein condensate , [ 6 ] atomic mass m is usually given in daltons , instead of kilograms , and chemical ...
The cm corresponds in the permeability equations to the thickness of the material whose permeability is being evaluated, the cm 3 STP cm −2 s −1 to the flux of gas through the material, and the cmHg to the pressure drop across the material. That is, it measures the rate of fluid flow passing through an area of material with a thickness ...
Allen Hazen derived an empirical formula for approximating hydraulic conductivity from grain-size analyses: = where Hazen's empirical coefficient, which takes a value between 0.0 and 1.5 (depending on literature), with an average value of 1.0. A.F. Salarashayeri & M. Siosemarde indicate C is usually between 1.0 and 1.5, with D in mm and K in cm/s.