Search results
Results from the WOW.Com Content Network
The two large integrated circuits below the middle of the image are the DMA controller (l.) and - unusual - an extra dedicated DMA controller (r.) for the magneto-optical disc used instead of a hard disk drive in the first series of this computer model. Standard DMA, also called third-party DMA, uses a DMA controller.
Intel 8237A-5, used on the original IBM PC motherboard Pinout. Intel 8237 is a direct memory access (DMA) controller, a part of the MCS 85 microprocessor family. It enables data transfer between memory and the I/O with reduced load on the system's main processor by providing the memory with control signals and memory address information during the DMA transfer.
A phase-locked loop or phase lock loop (PLL) is a control system that generates an output signal whose phase is fixed relative to the phase of an input signal. Keeping the input and output phase in lockstep also implies keeping the input and output frequencies the same, thus a phase-locked loop can also track an input frequency.
The Word DMA (WDMA) interface is a method for transferring data between a computer (through an Advanced Technology Attachment (ATA) controller) and an ATA device; it was the fastest method until Ultra Direct Memory Access (UDMA) was implemented.
If x 2 − y 2 is evaluated as ((x × x) − y × y) (following Kahan's suggested notation in which redundant parentheses direct the compiler to round the (x × x) term first) using fused multiply–add, then the result may be negative even when x = y due to the first multiplication discarding low significance bits. This could then lead to an ...
Dynamic mechanical analysis (abbreviated DMA) is a technique used to study and characterize materials. It is most useful for studying the viscoelastic behavior of polymers . A sinusoidal stress is applied and the strain in the material is measured, allowing one to determine the complex modulus .
The N 2 chart or N 2 diagram (pronounced "en-two" or "en-squared") is a chart or diagram in the shape of a matrix, representing functional or physical interfaces between system elements. It is used to systematically identify, define, tabulate, design, and analyze functional and physical interfaces.
The first step of computing an eye pattern is normally to obtain the waveform being analyzed in a quantized form. This may be done by measuring an actual electrical system with an oscilloscope of sufficient bandwidth, or by creating synthetic data with a circuit simulator in order to evaluate the signal integrity of a proposed design.