Search results
Results from the WOW.Com Content Network
The former Weights and Measures office in Seven Sisters, London (590 Seven Sisters Road). The imperial system of units, imperial system or imperial units (also known as British Imperial [1] or Exchequer Standards of 1826) is the system of units first defined in the British Weights and Measures Act 1824 and continued to be developed through a series of Weights and Measures Acts and amendments.
Imperial Ordnance QF 1-pounder "pom pom" Infantry gun/AA gun 37 mm 1.457 inch Ordnance QF 2-pounder: Anti-tank gun 40 mm 1.575 inch Ordnance QF 2-pounder "pom pom" Anti-aircraft gun 40 mm 1.575 Ordnance QF 3-pounder Vickers: Naval gun 47 mm 1.85 inch Ordnance QF 6-pounder: Anti-tank gun 57 mm 2.244 inch Ordnance BL 10-pounder Mountain gun ...
Volume may be measured either in terms of units of cubic length or with specific volume units. The units of cubic length (the cubic inch, cubic foot, cubic mile, etc.) are the same in the imperial and US customary systems, but they differ in their specific units of volume (the bushel, gallon, fluid ounce, etc.).
The British imperial system uses a stone of 14 lb, a long hundredweight of 112 lb and a long ton of 2,240 lb. The stone is not a measurement of weight used in the US. The US customary system uses the short hundredweight of 100 lb and short ton of 2,000 lb. Where these systems most notably differ is in their units of volume.
1.2 Centerfire cartridges imperial measurement. 1.3 Centerfire cartridges metric measurement. ... 7.62×42mm (wildcat) "30-400 Legend" necked down to .308 Caliber ...
SSA 7.62mm 143gr AP rifle cartridge, bullet. The 7.62 mm caliber is a nominal caliber used for a number of different cartridges.Historically, this class of cartridge was commonly known as .30 caliber, the equivalent in Imperial and United States Customary measures.
Overbore cartridges are those with a relatively large case volume or case capacity, coupled with a relatively small diameter bullet.. The case volume or case capacity and barrel bore area can be mathematically related to obtain a case volume to bore area ratio in metric or imperial units.
Conversion of units is the conversion of the unit of measurement in which a quantity is expressed, typically through a multiplicative conversion factor that changes the unit without changing the quantity.