Search results
Results from the WOW.Com Content Network
The power may be either in linear units, or logarithmic units (dBm). Usually the logarithmic display is more useful, because it presents a larger dynamic range with better detail at each value. An RF sweep relates to a receiver which changes its frequency of operation continuously from a minimum frequency to a maximum (or from maximum to minimum).
The AN/URM-25 was part of a series of vacuum tube-based signal generators built for the U.S. military in the early Cold War-era.. Today they are collected and used by vintage amateur radio and antique radio enthusiasts who say they provide reasonably high accuracy and stability for a low cost, with build quality reflecting tough military construction requirements and standards.
A dummy load is a device used to simulate an electrical load, usually for testing purposes.In radio a dummy antenna is connected to the output of a radio transmitter and electrically simulates an antenna, to allow the transmitter to be adjusted and tested without radiating radio waves.
The S stands for "Strength". Strength is an assessment of how powerful the received signal is at the receiving location. Although an accurate signal strength meter can determine a quantitative value for signal strength, in practice this portion of the RST code is a qualitative assessment, often made based on the S meter of the radio receiver at the location of signal reception.
The combined test signal can be injected directly in to the receiver if the antenna is removable. A second directional coupler, connected in the conventional configuration, can be used to provide a feed of the input to a spectrum analyser. This allows confirmation that the input signal is free of intermodulation products.
The RF signal is detected and fed to a microammeter, which is scaled in dBμ. The frequency range of the tuner is usually within the terrestrial broadcasting bands. Some FS meters can also receive satellite (TVRO and RRO) frequencies. Most modern FS meters have AF and VF circuits and can be used as standard receivers. Some FS meters are also ...
Several countries in ITU Region 1 have access to frequencies in the 70 MHz region, called the 4-meter band. The band shares many propagation characteristics with 6 meters. The preferred location for beacons is 70.000–70.090 MHz; [5] however, in countries where this segment is not allocated to Amateur Radio, beacons may operate elsewhere in ...
An RF switch or microwave switch is a device to route high frequency signals through transmission paths. RF (radio frequency) and microwave switches are used extensively in microwave test systems for signal routing between instruments and devices under test (DUT). Incorporating a switch into a switch matrix system enables you to route signals ...