Search results
Results from the WOW.Com Content Network
An RF switch or microwave switch is a device to route high frequency signals through transmission paths. RF (radio frequency) and microwave switches are used extensively in microwave test systems for signal routing between instruments and devices under test (DUT). Incorporating a switch into a switch matrix system enables you to route signals ...
The S stands for "Strength". Strength is an assessment of how powerful the received signal is at the receiving location. Although an accurate signal strength meter can determine a quantitative value for signal strength, in practice this portion of the RST code is a qualitative assessment, often made based on the S meter of the radio receiver at the location of signal reception.
Cable length limits the controller-device distance to two meters per device or 20 meters total, whichever is less. This imposes transmission problems on systems spread out in a room or on systems that require remote measurements. Primary addresses limit the system to 30 devices with primary addresses. Modern instruments rarely use secondary ...
Radio-frequency (RF) engineering is a subset of electrical engineering involving the application of transmission line, waveguide, antenna, radar, and electromagnetic field principles to the design and application of devices that produce or use signals within the radio band, the frequency range of about 20 kHz up to 300 GHz. [1] [2] [3]
ZVA40 vector network analyzer from Rohde & Schwarz.. A network analyzer is an instrument that measures the network parameters of electrical networks.Today, network analyzers commonly measure s–parameters because reflection and transmission of electrical networks are easy to measure at high frequencies, but there are other network parameter sets such as y-parameters, z-parameters, and h ...
The RF signal is detected and fed to a microammeter, which is scaled in dBμ. The frequency range of the tuner is usually within the terrestrial broadcasting bands. Some FS meters can also receive satellite (TVRO and RRO) frequencies. Most modern FS meters have AF and VF circuits and can be used as standard receivers. Some FS meters are also ...
A dummy load is a device used to simulate an electrical load, usually for testing purposes.In radio a dummy antenna is connected to the output of a radio transmitter and electrically simulates an antenna, to allow the transmitter to be adjusted and tested without radiating radio waves.
The combined test signal can be injected directly in to the receiver if the antenna is removable. A second directional coupler, connected in the conventional configuration, can be used to provide a feed of the input to a spectrum analyser. This allows confirmation that the input signal is free of intermodulation products.