Search results
Results from the WOW.Com Content Network
To match the impedances, both cables must be connected to a matching transformer with a turns ratio of 2:1. In this example, the 300-ohm line is connected to the transformer side with more turns; the 75-ohm cable is connected to the transformer side with fewer turns. The formula for calculating the transformer turns ratio for this example is:
Power input at port 1 splits and travels both ways round the ring. At ports 2 and 3 the signal arrives in phase and adds whereas at port 4 it is out of phase and cancels. Ports 2 and 3 are in phase with each other, hence this is an example of a 0° hybrid.
For an ideal transformer operating under ideal conditions, I s = I p /N, V s = N×V p. L p, primary (self-)inductance, a value determined by the number of primary turns N p squared, and an "inductance factor" A L. Self-inductance is often written as L p = A L ×N p 2 ×10 −9 henries. [1] R, combined switch and primary resistance
A double-tuned transformer from a radio receiver intermediate-frequency amplifier with its screening can removed. A double-tuned amplifier is a tuned amplifier with transformer coupling between the amplifier stages in which the inductances of both the primary and secondary windings are tuned separately with a capacitor across each.
Coupling coefficient, or coupling factor, may refer to: Electromechanical coupling coefficient; Coupling coefficient (inductors), or coupling factor, between inductances; Coupling coefficient of resonators; Coupling factor of power dividers and directional couplers; Clebsch–Gordan coefficients of angular momentum coupling in quantum mechanics
Network synthesis is a design technique for linear electrical circuits.Synthesis starts from a prescribed impedance function of frequency or frequency response and then determines the possible networks that will produce the required response.
Fig. 1 L P σ and L S σ are primary and secondary leakage inductances expressed in terms of inductive coupling coefficient under open-circuited conditions.. The magnetic circuit's flux that does not interlink both windings is the leakage flux corresponding to primary leakage inductance L P σ and secondary leakage inductance L S σ.
Transformers, autotransformers, and baluns are sometimes incorporated into the design of narrow band antenna tuners and antenna cabling connections. They will all usually have little effect on the resonant frequency of either the antenna or the narrow band transmitter circuits, but can widen the range of impedances that the antenna tuner can match, and/or convert between balanced and ...