enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Circlip - Wikipedia

   en.wikipedia.org/wiki/Circlip

   A circlip (a portmanteau of "circle" and "clip"), also known as a C-clip, snap ring, or ', [1] is a type of fastener or retaining ring that consists of a semi-flexible metal ring with open ends that can be snapped into place into a machined groove on a dowel pin or other part to permit rotation but to prevent axial movement. There are two basic ...

3. Retaining ring - Wikipedia

   en.wikipedia.org/wiki/Retaining_ring

   A retaining ring is a fastener that holds components or assemblies onto a shaft or in a housing/bore when installed - typically in a groove - for one time use only. Once installed, the exposed portion acts as a shoulder which retains the specific component or assembly. Circlips are a type of retaining ring.

4. List of screw drives - Wikipedia

   en.wikipedia.org/wiki/List_of_screw_drives

   11.5 External Torx. ... the PMT-000 can be used with screws that have a head diameter as small as 2.5 ... a 3 ⁄ 16-inch (4.8 mm) flat-blade screwdriver; at right, a ...

5. Headset (bicycle part) - Wikipedia

   en.wikipedia.org/wiki/Headset_(bicycle_part)

   38.1 mm (1 + 1 ⁄ 2 in), as used in the OnePointFive International Standard. Cannondale Headshok. Although a Headshok steerer is close to 38.1 mm (1 + 1 ⁄ 2 in) it is actually 39.7 mm (1 + 9 ⁄ 16 in). The headtube dimensions for 38.1 mm (1 + 1 ⁄ 2 in) and Headshok are very similar, differing only in the minimum press depth.

6. Set screw - Wikipedia

   en.wikipedia.org/wiki/Set_screw

   Isometric projection of a grub screw with a hex socket head.. Set screws are not always the best way to resist the torque of driven shafts. To reduce the chance of slipping and to increase load capacity, a detent (often called a "flat") may be milled or ground at the part of the shaft where the set screw's point contacts.

7. Wills Ring - Wikipedia

   en.wikipedia.org/wiki/Wills_Ring

   A Wills Ring or Cooper Ring is a form of all-metallic O-ring seal. They are used for extremely arduous service, such as sealing the head gasket of high performance piston engines . Hollow, metallic Wills Rings are used as they have better springback than yielding soft metal seals and higher temperature limits than elastomer O rings.