enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Distribution board - Wikipedia

   en.wikipedia.org/wiki/Distribution_board

   A distribution board (also known as panelboard, circuit breaker panel, breaker panel, electric panel, fuse box or DB box) is a component of an electricity supply system that divides an electrical power feed into subsidiary circuits while providing a protective fuse or circuit breaker for each circuit in a common enclosure.

3. Distribution transformer - Wikipedia

   en.wikipedia.org/wiki/Distribution_transformer

   The other end of the three secondary windings and the neutral are brought down the service drop to the service panel. 230 V loads are connected between any of the three-phase wires and the neutral. Because the phases are 120 degrees from each other, the voltage between any two phases is sqrt(3) * 230V = 400V, compared to the 2 * 120V = 240V in ...

4. Pad-mounted transformer - Wikipedia

   en.wikipedia.org/wiki/Pad-mounted_transformer

   Pad-mount transformers operate on medium-voltage distribution systems, up to about 35 kV. The low-voltage winding matches the customer requirement and may be single-phase or three-phase. Pad-mount transformers are (nearly always) oil-filled units and so must be mounted outdoors only. The core and coils are enclosed in a steel oil-filled tank ...

5. Circuit breaker - Wikipedia

   en.wikipedia.org/wiki/Circuit_breaker

   Front panel of a 1250 A air circuit breaker manufactured by ABB. This low-voltage power circuit breaker can be withdrawn from its housing for servicing. Trip characteristics are configurable via DIP switches on the front panel.

6. Switchgear - Wikipedia

   en.wikipedia.org/wiki/Switchgear

   High-voltage switchgear A section of a large switchgear panel. Tram switchgear This circuit breaker uses both SF 6 and air as insulation.. In an electric power system, a switchgear is composed of electrical disconnect switches, fuses or circuit breakers used to control, protect and isolate electrical equipment.

7. Fuse cutout - Wikipedia

   en.wikipedia.org/wiki/Fuse_cutout

   In electrical distribution, a fuse cutout or cut-out fuse (often referred to as a cutout) is a combination of a fuse and a switch, used in primary overhead feeder lines and taps to protect distribution transformers from current surges and overloads. An overcurrent caused by a fault in the transformer or customer circuit will cause the fuse to ...